The P0011 code for BMW vehicles indicates that the 'A' camshaft position timing is over-advanced or the system performance on bank 1 is not operating within the manufacturer's specified parameters. This can have a significant impact on the engine's performance and overall vehicle operation.

Your check engine light is on, so you break out your code scanner. The result is diagnostic trouble code P0011. What does the code P0011 mean? How can you fix it? Read on to find information about this code, its causes and solutions.

The BMW P0011 code is a fault code that indicates an issue with the camshaft position timing in the engine. Specifically, it means that the camshaft position is over-advanced or that there is a problem with the system performance in bank 1.

2023年1月7日 · The P0011 code means that the engine control module (ECM) received information that the bank 1 intake camshaft has progressed further than where it is supposed to be. While this is a generic code used by many automakers, the Nissan models tend to have a different meaning.

2013年12月17日 · The P0011/12/21/22 codes are all timing correlation codes, crank to cam. In order to set these codes, the sensor has to pass an electrical test set(fail = P0340/345), and the wave form has to be rational (fail = P0010/20).

2019年8月22日 · Code P0011 BMW Description. The Engine Control Module (ECM) controls the Oil Control Valve (OCV) to regulate the intake camshaft angle. As a result of the angle change, the engine timing is advance or retard.

2008年7月18日 · Trouble Code: P0011 "A" Camshaft Position Timing Over-Advanced (Bank 1) Possible Causes: * Fuel pump has failed * CPS circuit is open, shorted to ground or shorted to power * Battery voltage below 11.5 volts * Position actuator circuit may short to B+ or Ground * Camshaft timing improperly set, or continuous oil flow to the VCT piston chamber

The P0011 code indicates that the camshaft position sensor for bank 1 is detecting that the camshaft is over-advanced or that the system performance is not within the expected parameters. This can lead to issues with the timing of the engine, potentially causing poor performance, reduced fuel efficiency, and even engine misfires.

2008年10月18日 · My car is a 99 740iL with Vanos. I've replaced the Vanos solenoid and the cam position sensor and no help. I still get the OBDII code P0011 or BMW DTC fault code 33.

Engine started and driven at an engine speed of more than 400rpm; and the DME detected the camshaft timing exceeded the maximum calibrated advance value, or the camshaft remained in an advanced position during the CCM test. The valve timing did not change.