2017年9月16日 · In the same laboratory testing, DITRA-HEAT-DUO only reduced floor warming response time from 68°F (20°C) to 78°F (25.5°C) by approximately 20% (5 minutes) compared to DITRA-HEAT over a plywood substrate. Schluter®-DITRA-HEAT-E-HK heating cables were spaced at three studs in all of the above tests. Results above are based upon laboratory ...

2016年4月27日 · Ditra Heat calls for a 3 stud spacing on the heating cable. One way to achieve this would be to mentally break the Ditra Heat grid into 3x3 blocks of studs, and only install the cable on the edges of those blocks.

2020年1月2日 · The underlayment of the bathroom and shower floors is 5/8” plywood over joists on 16” centers and Deflecto shows about 400. He’s doing 100% Schluter products for waterproofing the shower. He’s also doing Ditra Heat for …

2018年4月9日 · Ditra/Ditra Heat Hybrid? RRGuy: Tile Forum/Advice Board: 6: 07-14-2016 07:25 PM: Ditra Heat Comments in Regards to Floor Heat: matthewstephanie: Tile Forum/Advice Board: 9: 03-17-2016 07:37 PM: Heat mat and ditra. Pumper50: Tile Forum/Advice Board: 10: 01-31-2015 11:39 PM: Ditra and heat mat: paulandkody: Tile Forum/Advice Board: 13: 02-29-2008 ...

First of all I like the Ditra heat system. I like the wire snapping right into the isolation membrane like it does and I think it's a great system. But, I wanted to see if anyone else has had the same issues I've had on a master bathroom floor. I installed a system that the contractor bought thru a …

Since you have Ditra Heat, I assume you also have the Schluter Ditra-Heat Installation book. I further assume you're following the tests outlined on Page 12. They are pretty clear in how to perform the tests. Assuming you are using the 3 meters correctly, you may well have two bad temperature sensors and you should contact Schluter for replacement.

Had a question regarding the right thinset to use over the Ditra Heat mat I will be laying down. I bought the only bag of Schluter All Set my local store had and also some Laticrete 254. I will have enough All Set to lay the mat, but not enough to fill the mat pockets and lay tile.

2024年11月7日 · Ditra Heat - Conduit Required? Starting a new master bath project using my (hopefully properly remembered) advice from this great forum. One question: it's not clear to me if Ditra Heat cables (cold lead and sensors) must be in …

2024年12月14日 · Natural Slate & Ditra Heat...questions: ThisOldCabinNJ: Tile Forum/Advice Board: 2: 08-09-2024 10:25 AM: Shower Project Questions - Kerdi/Thinset/Ditra Heat: J Walker: Tile Forum/Advice Board: 4: 02-20-2023 02:05 PM: Ditra Heat questions: andy911: Tile Forum/Advice Board: 5: 03-22-2020 07:39 AM: Ditra Heat over curbless shower change of …

2020年3月21日 · Hello, I am using Ditra Heat for my small bathroom. I had a couple of questions about mortaring: 1) I remembered from hanging Kerdi in my other shower that the fleece likes a wetter mortar mixture. For the Ditra I used Schluter All Set and mixed 4 …