DMA Software – Not loading up, entities disappearing or not showing, other anomalous behavior: This is most commonly caused by Paged Out Memory. When your system / target process are under High Memory Pressure, assets in memory may get shifted to your Page File.

Testing your DMA board from enigma-x1.com - Turn off your Main-PC - Plug-in your board into your Main-PC - Connect the USB-C cable with the Data Port on Enigma-x1/LeetDMA with your 2nd PC - Start your Main-PC and boot into BIOS - Make sure the green PWR-LED and the green LED is on - Disable/Adjust the following Settings:

2024年10月17日 · However it always has a green blinking light for the first few seconds of boot and then it goes solid red and isn't detected by windows once fully booted. Yesterday I flashed default pcileech-fpga firmware and I was still getting …

- Try changing the PCIe slot your DMA card is plugged into, or swapping it with another PCIe device like a network adapter or GPU. - Try changing which USB slot your device that has …

It is mainly for notebook customers to use DMA devices, because notebooks need to use M2 to PCIE transfer devices or Thunderbolt to PCIE devices. However, these two transfer devices cannot supply power to DMA devices, and an external power supply is required to supply power to DMA devices, which istroublesome.

When Card not detected on Slave or Main PC:

Verify that you are plugged into the JTAG Port of your DMA Card. Ensure you are using at least a USB 3.0 connection on your 2nd PC; Try a different USB-C to USB-A cable for connecting to the DMA card. Using the red on/off switch of the dma card, turn off the card while leaving the hosted computer on, wait 5 seconds and turn the dma card on.

Troubleshooting Please power off and reinstall the DMA, then confirm the status of the DMA indicator lights. If one light is constantly on and another light keeps flashing, it indicates a firmware problem. Contact the seller to obtain a new firmware.

Older builds of AKAIO featured different DMA modes. The software informed the user as to which DMA mode was working based on the color of the "Loading..." text; Yellow is an improved DMA mode, Green was the Quick-Save DMA mode which was previously the default in AKAIO v1.4 - v1.6, and Red was the original DMA mode.

2021年6月12日 · There's batch of craply made panels being sold where the red and green (possibly blue as well) pins have been wrongly wired to another color for the R2/G2 pins. No solution. You've bought a crap panel. Request a refund from the seller. Check the GPIO voltage from the ESP32 when 'HIGH' should be 3.3 volts. If less, then it's a defective ESP32.