FLUSH ALL WATER LINES PRIOR TO MAKING CONNECTIONS. !!! IMPORTANT !!! PROTECT THE FINISH OF SLOAN FLUSHOMETERS — DO NOT USE TOOTHED TOOLS TO INSTALL OR SERVICE THESE VALVES. USE A SLOAN A-50 SUPER-WRENCHTM, SLOAN A-109 PLIER WRENCH OR SMOOTH JAWED SPUD WRENCH TO SECURE ALL COUPLINGS. ALSO SEE “CARE AND CLEANING” SECTION OF THIS MANUAL. !!!

by stainless water closets and combination fixtures, the following procedures must be followed when installing the flush connection. failure to follow these procedures can result in separations. for secure connections in higher pressure and other severe condition applications, the flush connections can be sweat soldered. remove all plastic and

flush valves are designed to operate at water pressure between 20psi and 100psi. All plumbing fixtures requires at least 25psi with most requiring higher pressure.

A. Flush dirt, debris, and sediment from the supply line prior to connecting. MAKE SURE SUPPLY LINES ARE FLUSHED OUT. DEBRIS CAN DAMAGE THE VALVE OR CAUSE VALVE TO MALFUNCTION.

• WATER SUPPLY LINES MUST BE SIZED TO PROVIDE AN ADEQUATE VOLUME OF WATER FOR EACH FIXTURE. • FLUSH ALL WATER LINES PRIOR TO MAKING CONNECTIONS. The Sloan Flushometer is designed to operate with 15 to 80 psi (103 to 552 . kPa) of water pressure. THE MINIMUM PRESSURE REQUIRED SELECTED. Consult fixture manufacturer for minimum pressure ...

Typical Water Closet Installation Reference for RESS-C Retrofit Model 8115 & 8116 valves are designed for installations where the water supply is roughed-in 24” - 27” (610 mm - 686 mm) above the top of the water closet. When installing the Sloan ECOS® Electronic Flushometer in an ADA compliant stall: Per ADA Guidelines (section

• Flush valve should be installed to manufacturer’s installation instructions. • Turn on water supply valve. • Install toilet seat (not included). • Tighten the nuts carefully. • Flush water closet a few times and check all connections for water seepage. • Check for leaks. CARE AND CLEANING OF VITREOUS CHINA

WATER SUPPLY LINES MUST BE SIZED TO PROVIDE AN ADEQUATE VOLUME OF WATER FOR EACH FIXTURE. FLUSH ALL WATER LINES PRIOR TO MAKING CONNECTIONS. Sloan’s flushometers are designed to operate with 10 to 100 psi (69 to 689 kPa) of water pressure. THE MINIMUM PRESSURE REQUIRED. TO THE VALVE IS DETERMINED BY THE TYPE OF FIXTURE SELECTED.

2006年9月10日 · The flushometer's non-hold-open handle and absence of external volume adjustment help conserve water by ensuring that only the necessary amount of water is used for each flush. VACUUM BREAKER FLUSH CONNECTION: The flushometer is equipped with a vacuum breaker flush connection, preventing backflow and ensuring hygienic operation.

flush valves are designed to operate at water pressure between 20psi and 100psi. All plumbing fixtures requires at least 25psi with most requiring higher pressure.