2005年11月15日 · I'd say the build quality is likely WAY better on the tormek. The WEN is obviously an imported product made on the cheap. Your fit and finish will be lower for sure on the WEN, however, functionally you can get some pretty darn good results if you're willing to be patient. Many of the tormek Jigs do work on this machine.

2010年1月14日 · I inherited a Wen Wet Wheel. It did nothing, checked it and switch was bad. I emailed Wen and got a new one, perfect fit and wheel and sponge. I use it, like it. Never shocked me, I leave it plugged in when running water in it. If I find a manual, I will let you know. I was going to Wen on web to see if they have different coarsenesses of ...

2006年3月23日 · First, remove the stone holding the nut with a pair of pliers and a flat blade screwdriver. This is a left-handed screw. Now, exposed are 3-screws around the shaft and four around the periphery. Once those are removed, there are 5-long screws in the black case. Cut the label with a sharp knife as it sits across the two body halves.

2018年3月31日 · hello everyone, I’ve been researching and looking everywhere for information on the wen knife sharpener. Right now I use a Lansky and while sharping a knife that already has a initial edge is easier I’m looking for a new sharpener to help create those secondary bevels and nice edges. I know...

2009年4月12日 · The above image is from the WEN web site (link below). It's a replacement wet wheel for the 4270, and the label shows it uses a 1/2" arbor. Another site page for the tool itself describes the wheels as 10" dia. x 2" width in size. So, with that info, it'll hopefully be easier to search for aftermarket wheels that might work.

2004年4月13日 · ETA: After some use, I've decided that I don't like the Norton Norax ceramic 1,200 grit belts for knife sharpening. The ceramic is just too aggressive for a knife edge IMO. Takes off steel really fast, and gets the steel pretty warm relatively quickly when I was testing them on some cheap stuff. I'll be sticking to the regular Al Oxide Norax ...

2014年10月15日 · Knife thicknes causes angle to be added: say 15 goes to 17 deg. Oposite goes for: there is a guide, then the knife leaned on it and the sharpening surface is on the oposite side of the guide. Knife between them moves its center …

2018年8月20日 · DMT 600 grit diamond sharpener - $35 KO Worksharp - $130 1x30 belt sharpener - $50 HF 4-Sided Diamond Hone Block - $13 At this point, I think that the Harbor Freight 4-Sided Diamond Hone Block is the best value in sharpening that I know of, especially if you have supersteels. If you use a 20% off coupon, it comes out to a little more than ten ...

2022年9月25日 · I solved that with a $1.50 spring from the hardware store. Now I don't even bother tightening the stone retaining screw, although I probably should. The second issue occurs with some blades shapes. To be fair, no high end knife sharpener seems to handle every blade shape with a single set of clamps.

2014年2月15日 · Jet Wet Sharpener $315 plus $40 if you want a blade jig (I don't use it, preferring to get a convex edge doing freehand) The Jet can be upgraded with a lazy susan, and a two drawer pedestal. Those two items, push the Jet to over $400 total cost. WorkSharp Ken Onion with Blade Grinder, and two sets of belts, including leather strop $$315