2022年10月27日 · Per the instructions you use the 36 inch line to run from the Pedal Height Valve to the slave Cylinder, And the 12 inch from the Clutch Master Cylinder to the Pedal Height Valve mounted under the dash. But the Instructions also say you can put the Pedal height Valve anywhere between the Clutch Master and the Slave Cylinder.

2015年2月7日 · My clutch pedal is soft. I have tried to bleed it but no air is coming out. I replaced the slave cylinder a few months ago, as well as the master cylinder. The slave cylinder is a good product, but I don’t know about the new master cylinder. It may have been a cheap product. There is no fluid leaking out, I checked under the floor mat by the pedal, the lines look fine and the …

2017年11月4日 · 2006 Toyota Camry 108K miles. It still has factory clutch. Since two nights ago, when I step on the clutch pedal and press it down, it has begun to make mild squeaking noise that’s kind of sounds like when you are rubbing two hard rubber surfaces. This squeak happens whether the engine is running or not, and it’s only when the clutch pedal is going down and not …

2017年10月23日 · A failed clutch MC could cause the clutch pedal to stick to the floor, but that would be an unusual symptom. There’s a couple of springs that should return the clutch pedal to the up position – possibly abnormally slowly — even if the MC was faulty. But you could have multiple problems, so the clutch MC remains a suspect.

2013年7月5日 · a. If pedal feels hard in a short distance, air is present in the clutch slave cylinder. b. If pedal feels spongy, air is present in the clutch master cylinder. 3. Continue checking the fluid level while depressing and releasing the clutch pedal. Depress and release the clutch pedal until an appropriate clutch pedal response and feel is achieved.

2012年12月23日 · Maybe there is something wrong with the clutch pedal hinge or something is preventing it from freely moving, like a broken spring. Or the clutch itself could be failing. An experienced mechanic can probably tell just by the way the clutch pedal feels. The force shouldn’t vary over time as you hold the clutch halfway to 3/4 down.

2015年1月27日 · When I got it back the clutch pedal feels very soft and goes to the floor with ease, whereas before it was a lot harder and felt good. It works good and dosen’t slip but just a soft pedal. I also went for the OEM replacement and not aftermarket. Some of the google searches I’ve read say the pedal will get harder after about 1000-2000 km.

2014年10月19日 · I have a 2001 Civic LX; I would like the clutch pedal travel distance to be far less than it is. As in most manual cars, I find that the clutch pedal travel is mostly useless. That is, once the clutch is fully engaged, the pedal still has a goodly way to go before it hits the stop. On pedal depression the inverse is true. As modern hydraulic clutches are self-adjusting, this once …

2014年10月7日 · My 1999 Toyota Tacoma (Ext Cab, 4x4 TRD) has 162K miles and now the clutch pedal intermittently sticks to the floor. I have to pull it off the floor with my toes while driving and have also felt the pedal start to pull back towards the floor on its own while the truck is in gear. I’m looking for some wisdom as a few blogs/websites point towards a master cylinder, …

2010年1月29日 · Hello, I have a Kia Spectra 2005, manual transmission. Last night I was stuck in traffic because of an car accident. After about 45 minutes of stop and go, the clutch started making a squeeky noise when I stepped on the pedal, and when it return to the normal position. Little by little the clutch pedal started getting loose and looser, ie. I felt very little resistance as I …