
Rifle Scopes Kahles 3GR and Sl1 Reticles - Sniper's Hide
2020年8月7日 · "The 3GR is built around a 100 yd zero for common centerfire rifle cartridges, with each line in the tree below it extending down 1 mil from the previous line. The 2nd, smaller illuminated aiming point is at the 2 mil mark, which corresponds to roughly 400 yds across a variety of common semi-auto rifle configurations and loadings.
SOLD Kahles K18i-2 1-8x24mm scope with 3GR reticle - Sniper's …
2024年12月14日 · For sale: Kahles K18i-2 1-8x24 scope with 3GR reticle The scope comes with the 3GR reticle, two interchangeable throw levers (one long, one short), cover, and original box/papers. It has a large 150 ft FOV and a daylight-bright illuminated reticle with a MAX LIGHT function for extreme backlight situations.
Rifle Scopes Kahles K18i 1-8x24i 3GR Riflescope - Sniper's Hide
2020年1月23日 · The only thing I wish the K18i had was the "fin" throw lever from the K16i, instead of that huge one they put on the K18i and I wish the 3GR had it's mils numbered. For those that prefer FFP, the Kahles will not even be looked at.
The revised Kahles K18i-2 with a wider FOV - Sniper's Hide
2021年3月29日 · Happy to see they got rid of that 2nd 2-mil dot that was fucking up the works on the previous 8x and 6x model 3gr. I had yet to come across anyone in a class or match that like or wanted to keep that feature.
Rifle Scopes Kahles K18i arriving finally - Sniper's Hide
2020年3月25日 · The reticle I have in the K18i is the 3GR, and being SFP, the etched marks are only good at max magnification. Note that unlike the vortex, there are no numbers on the holdover marks on the Kahles.... but I would also note that the etched reticle on the Vortex are really only useable from 5 power and up (though it could be used at lower power ...
Hornady 68gr BTHP & varget | Sniper's Hide Forum
2011年1月23日 · Finally got some range time in today. Ive been wanting to try out some varget loads out of my RRA Ar15. Loaded some rounds up. Started at 23 gr and went up to 24.4 gr. I had no over pressure signs at all. I'm pretty happy with results from today. I …
Harrell's powder measure | Sniper's Hide Forum
2009年4月3日 · I've only thrown varget and H4350 so far and it's held +/-.1gr if I'm consitent on the handle. If I get a really hard crunch that rattles the whole measure or I'm too fast on the handle the charge will vary. I haven't seen more than .3gr of deviation during one of those "funky" throws. From what I've heard, ball powders throw pretty much dead on.
Sierra SMK 175 & Varget loads | Sniper's Hide Forum
2018年3月21日 · Terry Cross built me a 308 yrs back. Told me to ld 43.3gr Varget, 175 SMK, Lapua brass. Told me it would do 2700fps. He was right on!! Shot lights out to boot. Its all I ld for 308’s still. 6mm’s, 6.5’s, exotic 7’s have all become the rage. 20” 308 w above ld is still a …
.308 with Hodgon Titegroup. | Sniper's Hide Forum
2010年5月13日 · I've gone as low as 3gr of Titegroup in .38 loads without failures or issue. If they're saying 8gr works, compared to my 3gr thats 37.5%... so according to my shotty math, the ratio of 8gr to .308 case capacity is higher than the 3gr of Titegroup I've used in my .38 loads.
.308 w/ IMR 4064 and 175 SMK | Sniper's Hide Forum
2014年7月4日 · 43.3gr in LC13 brass, with Tula primers is a *touch* too much in a friends SSG3000, though it shoots beautifully there. Average MV is 2695fps, measured via magnetospeed. BCP