How to Install or Replace Back-up Alarm - YouTube
How to Install or Replace Back-up Alarm simple to connect all the wires #backupalarm #howto #reversealarm
This back-up alarm will automatically turn on with a beeping sound and a bright flashing light when the vehicle is in reverse, when wired correctly at an operating voltage of 10-80 volts DC. Never install the back-up alarm in a confined area or in a compartment where the sound level of the alarm can be reduced and the light blocked from view. Never
How to install back up alarm - YouTube
2022年9月9日 · How to install back up horn to any kind of vehicle easy installation all wires need to connect to your reverse light only the positive and negative of your r...
Back-Up Alarms are designed to provide a warning sound to signal that a vehicle or mobile equipment is reversing. In order to ensure the correct operation of this critical warning device, it must be installed in conformance with the instructions provided in this guide and it is
connect the black wire to the - terminal on the alarm. Torque the screws to a maximum of 12 in-lb (1.3 Nm). To generate a constant tone, use a #6-32 by 1/4-inch
Back-Up Alarms are designed to provide a warning sound to signal that a vehicle or mobile equipment is reversing. In order to ensure the correct operation of this critical warning device, it
Solder splice the alarm’s signal/power circuit to W751 per the alarm’s instructions. If the alarms signal/power circuit is not long enough, the circuit can be extended using a minimum 16 AWG wire. Cover all splices with sealing heat shrink tube. Insure that the heat shrink tube is appropriately sized for the wire being used.
The back-up alarm system must be inspected each workday at the beginning of each shift to ensure that it is audible, operating properly, and securely at- tached to the vehicle. Inspect more often when: 1) The vehicle is operating in an adverse environment; 2) The vehicle is operating in foul weather con-
All wire routing going through drilled holes should be protected by a grommet or convo-lute/split-loom weaving. Cut a 3-inch diameter opening for the alarm at the desired location. Orient the grommet with the lettering upright and insert it into the opening for the alarm.
• Locate the back-up alarm so it will operate safely under all conditions. The location must provide protection from impact and adverse weather conditions while allowing unobstructed sound projection to the target hazard area. • All effective back-up alarms produce loud sounds which may cause, in certain situations, permanent hearing loss.
- 某些结果已被删除