2009年10月2日 · The Camshaft Position Sensor and the Crankshaft Position Sensor can both be tested with a $10 volt/ohms meter. CPS Testing Crankshaft Position Sensor (CPS/CKP) TESTING PROCEDURE 1991 - 2001 4.0L H.O. engines 1. Near the rear of intake manifold, disconnect sensor pigtail harness connector from main wiring harness. 2.

2012年5月19日 · I replaced the transmission a few months ago and have put a total of 3 different crankshaft position sensors in the vehicle, so I don't think it's that. The current crankshaft sensor is new and only 3-months old. Do the symptoms sound like a faulty camshaft position sensor? I plug wire are new and the plugs look good - gapped correctly and all.

2015年10月14日 · Which means when the sensor is faulty, it gives your Jeep's computer false data, which can result in the timing being off, misfires, and rough idle. The process is not too difficult and it's worth doing at home to save some money on labor. Read on to learn how to replace the camshaft position sensor. Figure 1. Camshaft position sensor.

2015年1月17日 · Replaced crankcase position because it was a cheap one and I had an oem in my box. Pulled the camshaft sensor to check things out and I'm measuring opens across all pins. Just wondering if it's one of those sensors that you can't meter or it's truly toast. I have no voltage whatsoever at the coil. Thanks in advance. Butch

Location for the camshaft sensor for 2016 Jeep Cherokee trailhawk 3.2 l. It pulled up the code. 139545 ...

2010年12月25日 · Remove the camshaft position sensor from the camshaft synchronizer. Loosen the retaining fork that holds in the camshaft synchronizer. Find the small hole in the outside of the housing for the oil pump drive shaft. Find the small hole on the magnet inside that indicates camshaft position.

2016年7月18日 · So the cam shaft position sensor is best attacked from underneath the jeep. It does not need to be jacked up. The sensor is located on the passenger side (e.g. ‘right’ side) of the engine. It is held in by a 10MM screw. The FSM says to release the connector then unscrew the bolt holding the sensor.

2009年1月25日 · The Camshaft Position Sensor (CMP) on the 4.0L 6-cylinder engine is bolted to the top of the oil pump drive shaft assembly (Fig. 7). The sensor and drive shaft assembly is located on the right side of the engine near the oil filter (Fig. 8). (1) Install sensor to oil pump drive. (2) Install 2 sensor mounting bolts and tighten to

2010年12月9日 · code p0340 =- No camshaft signal being received by the computer This indicates that a problem was detected in the camshaft position sensor circuit. The problem could lie in any part of the circuit - the sensor itself, the wiring, or the PCM. This code often is associated with a bad Crankshaft Position Sensor, which is a common problem in cherokees.

2011年2月15日 · The 1997 Cherokee doesn't show a Crankshaft sensor for a manual transmission. However, if you drop back to a 1996, there is a Crank Sensor listed for a manual transmission. You might want to take the sensor that came out of the vehicle, for a walk to your local parts supplier.