2006年2月26日 · Clean the inside of the spring eyes and the frame rails with WD40 and a wire brush or sandpaper. Now you can start to install the new bushings. Make sure you use plenty …

part 2 completes the remaining install and shows direction of bolt locations.

Part one of the installation of the bushings at the front leaf springs. I thought I had to use a press, but went in very smoothly.

I couldn't take my "saggy" rear end on my 1968 Chevrolet Camaro anymore so I installed new leaf springs as part of my "Revival Series". In this episode I wil...

2006年7月26日 · Typically new springs come with new front eye bushings pre-installed, these are press in items. An "installation kit" would come with new shackles new rear bushings (slip-in), …

2006年7月11日 · I am replacing my leaf springs with the Hotchkis springs on my 69 Camaro. The bushings that go into the frame that the rear shackles hang on do not want to go in easily. I …

2008年8月11日 · I am going to install the front leaf spring eye bushings on my car and was wondering if the flange goes toward the outside or inside of the car? Also, should you bottom …

If you’re keeping the spring or want to remove the rubber leaf spring bushings on your own for installing polyurethane bushings, there are two ways to remove them without a hydraulic …

Remove the front spring pockets from the old springs and install them onto your new springs using the factory bolt and nut. factory or aftermarket leaf spring pads up into the spring …

2012年7月8日 · To install the spring, place the poly bushings in the rear eye (with plenty of grease) and make sure you're using the right pair of bushings - the frame and spring bushings …