2016年6月29日 · Either your airbag really is bad and needs to be replaced, your solder connection is no good, or oddly, the other plug on the harness is causing your code.

About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy & Safety How YouTube works Test new features NFL Sunday Ticket Press Copyright ...

2014年6月11日 · VW is telling you to cut out the connector completely. Connect each wire where it is supposed to go by joining the wires, soldering them, and then sliding shrink tubing over each joint so that the joints do not short out to the frame or …

What to do when moving the driver's seat back causes the airbag MIL to turn on, and no matter how many times you read and clear the code (DTC 01217) using a ...

2011年12月13日 · 01217 - Side Airbag Igniter; Driver Side (N199) 001 - Upper Limit Exceeded - Intermittent - MIL ON I put leathers into my 3dr a couple of weeks ago, all was fine at first. After a few miles the cluster airbag light started coming on. Sometimes if I cleared it, it'd not return for a bit. Now it's on pretty much constantly.

2019年8月19日 · I ran a scan and at address 15: Airbags, had 1 fault found : 01217 - Side Airbag Igniter; Drivers Side (N199) 33-00 - Resistance Too Low.

The code is 01217 which says the drivers airbag resistance is too high. I have replaced both the clock spring and the air bag and I still have the air bag light on. I have also replaced the original module (1C0909605T016) with one from another Beetle that has never been in an accident.

2011年2月9日 · The code is 01217 which says the drivers airbag resistance is too high. I have replaced both the clock spring and the air bag and I still have the air bag light on. I have also …

2009年1月28日 · I do not have a VAG-COM however the shop I took it to does. They retrieved codes for drivers side and pass side airbag igniter's. The codes were 01218 and 01217. The tech was able to "clear and reset the unit" and the Air Bag light is now off!!!!!

2004年8月12日 · DTC 01217: Side airbag igniter driver's side (N199). 32-10 resistence too high - intermittent. Anyone run into this or have any ideas what I should look at? The new owner isn't too happy and I told him I'd try and fix it for him...