My kia rio 2005 overdrive not working properly, sometimes stays in 3rd gear running at 50 or 60 mph...help please get car scanned-cud be a stuck shift solenoid caused by bad or low fluid--also older trans have worn parts like clutches or a # of other things-may just need an ajust on the line pressure or throttle cable

2012年6月4日 · On 2003 Kia Rio the knock sensor is located under the intake manifold and must be changed from underneath the car. If you remove the oil filter it is directly above it and is in clear view once the oil filter is out of the way.

04 kia rio , engine made noise than stopped ,now wont turn over. just shut off after making noise while driving,now - Kia 2004 Rio question Search Fixya Press enter to search.

2015年4月21日 · In what sequence do the coil spark ? 04 kia rio 1.6 L - Kia 2004 Rio question

P1166 code displayed on 04 KIA RIO with 1.6 eng. The check engine light came on within 2 Hrs. running time after timing belt repl. P1166 refer to O2 sensor heater circuits malfunction, HO2 Heater system electrical, bank 1.

2009年2月28日 · In a 2006 Kia Rio, the EGR (Exhaust Gas Recirculation) valve is typically located on the engine, near the intake manifold. The EGR valve is responsible for recirculating a small amount of exhaust gas back into the intake manifold to lower the combustion temperature and reduce the formation of nitrogen oxides (NOx) emissions.

2011年9月4日 · I just bought a 04 kia rio wagon , it idles good at first , but when you drive it for about 40 miles ,after it gets good and warmed up , the car will not idle , then when you let it sit for a few minutes , it will idle again , i tokk it to four different mechanics, and they cant even figure it …

2010年12月16日 · 04 kia rio 1.6 . both cam sprockets are the same. do I put the cam dowels in the up position to locate the I for intake and E for exhaust. These sprockets can be put on 180 deg. apart. Posted by pharder_donn on Dec 16, 2010

P1166 code displayed on 04 KIA RIO with 1.6 eng. The check engine light came on within 2 Hrs. running time after timing belt repl. Posted by papakolea on Jun 30, 2010

2012年3月20日 · SOURCE: Replacement of a 2004 kia rio rear drum stud Loosen the remaining lug nuts, then jack up the car, take off the wheel, and ease off the brake drum. Whack the end of the stud to start it out of the hole, then take a rod, buggered up socket extension, or other object and drive out the stud the rest of the way.