Is the door gap adjustable? - Chevy Message Forum - ChevyTalk
2012年3月31日 · If you're happy with the door fit then you need to pull the bottom of the fender forward. The door should only be adjusted to get good door to quarter and door to rocker gaps. The fender is then aligned to the door.
getting panels to line up straight - Chevy Message Forum
2002年3月28日 · Is there a best way or recommended way to get panels to line up , I figure to start with the door to rear quarter panel gap and then move onto the fenders then hood then front valance panel. ( bumper / grill / radiator support panel )
alligning impala doors - Hot Rod Forum
2010年1月2日 · Close the door, and with the hood open adjust the gap at the top of the rear of the fender to door. After you tighten other bolts this cannot be modified so, do it first. Tighten the bolt under the hood closest to the door to secure the position.
Fender gap at door?? - Chevy Message Forum - Restoration and Repair …
2006年5月5日 · There really is only one way to make the fender/door gap even (assuming they are fitting properly) and that's by rasing or lowering the front of the fenders. Since the front of the fenders are bolted directly to the radiator support, the support must be rasied or lowered.
door to fender gap too wide HELP please - The 1947 - Present …
2008年11月8日 · Loosen the rear cab bolts, remove the front cab bolts, and make sure your fender bolts are loose. Then jack the front of the cab up untill the door gap is right and tighten the fender bolts. (All 3 rear ones) Let the jack down and you should be good to go.
The most frustrating part of the build? Door alignment? - The …
2008年9月17日 · I test fit a front fender last night, and in addition to being too tight to the fender (and consequently a big gap at the rear; ie doors needs to go backward despite being as far as it goes) I also determined a very interesting thing; despite the bottom bing too far out,. the front is …
Passenger Front Door-Fender Gap - 60IMPALA.COM
Passenger front door to fender gap – BEFORE So to fix it, I took some tig-welding rod and welded it to the edge of the door, first tacking it in every inch or so to hold it in place. then I repeated those tacks until I filled the gaps, being careful not to over-heat the area and warp the door skin.
Fender and door adjustment - Chevy Impala SS Forum
2018年8月4日 · Fender is back too tar and leaves a gap at rear of Corning light and gets mangled by the door. The fender and door were hastily replaced after a deer and I took in the project. So, I have been searching for alignment tutorials and came up short. I have the factory service manual for my 96 FW, but am confused by much of the instructions.
Alignment on 65 impala SS - Hot Rod Forum
2008年6月23日 · I recently purchased a 65 Chevy Impala SS that was stated to be "mint" and as you may have surmised, it ain't. One of the issues I have is that the drivers front tire rubs momentarily on the front of the wheel well (fender)when turning in either direction.
Fender/Hood Alignment on 65 Impala - Hot Rod Forum
2012年5月25日 · I finally got the front clip for my 65 Impala back on and I'm having Alignment problems. I measured everything up and it appears that my left front fender is about 5/8" shorter (front to back) than the right one. At least the measurement from the cowl grill to the back of the front valance is that much shorter.