2012年4月2日 · I love my PH-1r something fierce. It's simple enough with only 3 knobs yet versatile enough with the resonance control. BUT the volume boost has been getting to me lately and though I love the sound it drives my amp too hard when I want to use it on lower gain stuff. What phaser has a similar...

2015年8月26日 · But the Kinman circuit (.0012uF cap + 130k resistor, in series) is designed for single coil pickups using 250k pots and doesn't seem to work as well with humbuckers and 500k pots. I think I've read that for 500k pots the resistor value should be changed to something like 220k or 250k and that the .0012uF cap would stay the same value.

2013年9月20日 · i'm considering replacing the volume pot with a 250k pot so it works with the alumitone. however, it seems that this could adversely affect the signal of my bridge humbucker, so i though of putting a 250k resistor in series between the bridge humbucker and the volume to compensate. 1. will this work? 2. do you have a better idea? 3.

2015年12月3日 · Two volumes and a master tone could work. I say go for that or the load/resistor trick. -Resistor being my first choice in this case. I think the V70's would prefer to see a bigger cap value than the SSV. You'd have to keep the capacitor on a master tone low for the humbucker.

2007年10月29日 · neil, The controls are available separately but they are on the same circuit card in the DG20. I was told by someone at EMG that the very early DG20 sets also used the separate SPC/EXG controls but they soon switched to another card that had both the SPC and EXG on it.

2009年11月5日 · Putting a resistor across the two hot lugs of an audio volume will "flatten" its curve, reducing the drop; the smaller the resistor, the bigger the difference. about half the pot value seems to be the norm, like 200-300k across a 500k audio taper pot to …

2009年12月18日 · Over a year ago I switched to a tele for full time gigging (really my only guitar) and lots of hard rock stuff. Put in a resistor and cap for the treble thing and chose the values with the amp on a clean at a low volume. Sounded really good. Also allowed the volume knob to be useful over a wider range. Fast forward to yesterday.

2020年6月13日 · Beats the heck out of trying to guess the right capacitor and resistor value to use. Made a huge improvement with my '99 standard (stock pups) Reactions: Dusty_Dave , indexless , modavis99 and 1 other person

2015年3月2日 · Experiment with up to a 1000pF cap and down to a 130K resistor. I have a Tele that nailed it with a 1000pF/150K and a Strat with 680pF/130K. Depends on the pickups. For $40, one can have 5 each of the following and a 6-pack to drink while experimenting with combinations that work best in the specific guitar. 330, 470, 680 and 1000pF caps

2022年8月4日 · I have a 2016 PRS McCarty Double Cut 594 with 58/15 pup's that has a pull-up coil tap on the tone pots for each pickup - I think it takes them to Parallel from the normal Series wiring (there is a slight volume drop when you pull that tap pot, not as severe a drop as most tapped HB's I've encountered), I've also read that PRS puts some kind of resistor on those tap-pots for the 594.