2005年12月10日 · A friend of the wifes has a 92 S-10 Blazer that is stuck in 4 low and it won't go back in to 2wd drive.. So how do you get it to disengage to go back in 2wd...

2001 Chevy Blazer 4-wheel Drive Does Not Engage My Blazer's 4x4 System Suddenly Stopped Working. I Press The Button To Go To 4 High And No Clicks Or Any Indication And Light On 2 High...

To properly shift your vehicle into 4-Lo, you know that you have to shift the transmission into neutral and slow down to less than 5 mph. Once your vehicle slows down to this range, your can switch your transfer case into 4-Lo mode. Due to the inner workings of the transfer case, the actual shift into 4-Lo may take a few seconds to complete.

2008年6月2日 · I have a 2001 chevy blazer with a 4.3L v-6 with electronic 4 wheel drive. It is shifting from 2-high to 4-low after a short drive from beginning point. I can stop the vehicle, put trans. shift into ne

2011年8月29日 · Check your Owner’s manual to confirm. A GM mechanic told me to engage 4wd every week or two, otherwise the TCCM (Transfer case control module) locks up. He suggested disconnecting the cable at the TCCM to reset it. When the 4wd drive starts acting up on my Blazer, I disconnect the battery for a few minutes to reset the TCCM.

2011年2月16日 · The 2001 Chevrolet Blazer has 1 problems reported for stuck in 4-wheel drive. Average failure mileage is 142,200 miles.

2014年3月8日 · My 2001 Chevy Blazer seems like its stuck in four wheel drive. Was stuck on a sheet of ice and decided to place in four wheel drive. Got out of the ice and shifted back into two hi. drove off and started hearing a whirring sound like if I had over sized tires. tried reshifting from four lo to four hi (engagement felt and heard)and back to two hi.

If the 4x4 light on your 2001 Chevy Blazer is blinking when you try to engage 4 Hi or 4 Lo, it indicates a problem with the 4WD system. When the light blinks instead of going solid, it typically means that the transfer case has not fully engaged into the selected 4WD mode. Here are some possible reasons for this issue:

Hey, my Trail Blazer is stuck in 4wd drive. how do i get it out? Reply 1: scan for codes first and check fuses either can cause it then check encoder ...

2008年2月8日 · 2001 blazer: wont shift out of automatic 4 wheel drive..low range… The only way to get it back into 2wd is by fixing the problem. There is an encoder motor on these vehicles. It is located on the transfer case. The first thing you will need to do is check for codes in the transfer case module here are the instructions on how.

2011年11月4日 · 1998 Blazer ZR2, Stuck in 4wd HI; goes 4HI/4LO ok, won't go to 2wd HI. I can switch from 4HI to 4LO to 4HI all day, but it won't go into 2HI. I pulled the battery and tray out and found the diaphragm sucked in, pulling the cable. But the cable was rusted through the outer jacket and totally frozen.

The 4 wheel drive won't disengage on my 2001 Chevy Blazer. I have to put it in reverse and turn the wheel all the way for it to release. Also has a clunk in the transfer case.

2013年4月13日 · 01 1500 that has a growl (as in 4 wheel). crawled under and front shaft is engage, selector light says 2hi. tired shifting through all, hear motor react...

My blazer's 4x4 system suddenly stopped working. I press the button to go to 4 high and no clicks or any indication and light on 2 high stays on. Any thoughts? What I need you to do is check for power to the actuator on the transfer case. It is an electric motor that shifts the transfer case for you. Let me know what you find. helpful?

There really are only 2 options at this point, the first is to diagnose the problem and the second is to remove the shift motor and shift this manually (this can be done but its not easy), do this is manually the front drive shaft needs to be removed and the shift motor on the side of the transfer case removed, then a pair of pliers can be used ...

2012年12月12日 · It's most likely the "four wheel drive actuator" This is located on the front differential housing. It's cylindrical shaped and has a large hex (about. 1-1/4") and two wires coming out of it. Usually they short out and blow the fuse but, I've also seen where they just quit working and sometimes they just get slow to work.

2022年11月8日 · My Blazer Is Stuck In 4 Low. If I Push The Button For 2 Wheel It Flashes Then Goes Back To 4 Low. I Have Checked The Relay Wiring And Also...

2014年1月9日 · I Have A 2001 Chevy Blazer The 4x4 will not engage. I Press the 4x4 Auto, Hi or Low button on the dash they just keep flashing. you can here the transfer case engage, but It will not be in 4 wheel drive.

By being stuck in 4WD, is it in 4lo? If it is, and it won't shift out of 4lo, are you trying the shift with the transmission in neutral? The next step would be to check for trouble codes, and with your system, that is achieved by grounding pin 13, an orange wire, at …

The likely problem is the vacuum switch has a leak in it and when the vacuum rises it activates the front axle interlock. When you shift it the valve gets moved and the vacuum bleeds off and then the problem starts over. Pull the vacuum line off of the actuator (under the battery) Or follow it up to the nearest connection and disconnect it.