2014年3月5日 · The 6-50r natural habitat is the inside of any kind of repair or manufacturing shop. Last edited by mad welder 4; 03-05-2014 at 12:41 PM . old Miller spectrum 625

2010年4月23日 · Just pull the 14-50 from wall box and swap in 6-50R with matching cover plate....Make sure to rotate 6-50R with round ground hole up.....inside outlet wall box, use black to one spade, red to other spade, bare to ground, and tape off white.....Back at the panel, pull white from grn/common bar and tape off.

2010年4月22日 · I just bought a miller 211 and would like to wire it to my dryer circuit. I have searched and read lots of posts that talk about making an extension cord with a Nema 6-50 input for the welder and a Nema 10-30 output to plug into the existing receptacle.

2021年3月2日 · Unless you have a local amendment, there is no such thing in the NEC, the code panels refuse to touch the issue of up/down, professional electrical forums lock threads where the issue is brought up, it boils down to personal preferences, or job specs, anyone who says that ground up is the correct way or ground down is the correct way is wrong, unless we are talking …

2014年1月14日 · Done! I made two short welder adapters (one NEMA 6-50r to older dryer male/plug; one NEMA 6-50r to newer dryer male/plug)---these are not for home use, just when I'm at friends' houses and I have to perform the favor there; that's all. I'm doing welding favors occasionally, but just enough that it's now required and a convenience for me.

2008年1月28日 · Replacing it with a 6-50R, 50-amp receptacle is a no-no. It should be replaced with a 6-30R, 30-amp receptacle to match the 30-amp circuit and the welder's plug should be changed to a 6-30P. If that is not enough juice to run the machine, then the circuit needs to be upgraded (wire size and circuit breaker rating) to handle the increased ...

2022年8月16日 · I am wiring a 6–50R for a Lincoln AC/DC using 6/2. On the receptacle, there is an x y and g label. I know G is for ground but does it matter which wire (white and black) go in the X and Y spot?

2014年3月8日 · I bought a 6-50r receptacle and a 50A double pole breaker. I assume since there are only 3 prongs on the plug and receptacle that I should use 8-2 romex instead of 8-3 and connect the white and black hot wires to the straight prongs on the receptacle and the connect the ground wire to the round/U shaped lug?

2019年9月30日 · nema 10-50 to 6-50R adapter The 10-50 shows a neutral and the 6-50R shows a ground. How do I do this ...

nema 14-50p to nema 6-50r. Adapts engine drive 120-240-volt plug to common Millermatic® and Spectrum® 240-plus. For use with Bobcat™ / Trailblazer® / Big Blue® (except 400 and 500 CC).