plot(mnl) plots the output signal power and the phase change versus the input signal power. This syntax is equivalent to plot(mnl,'Pout'). plot(mnl,'Gain') plots the gain and the phase change …

2024年11月21日 · I have .txt files that contain complex input and output baseband signals of an amplifier. I need to plot the AM/AM (magnitude of Gain vs. Input power) and AM/PM (phase of …

2022年4月6日 · 观测AM/AM、AM/PM是识别记忆效应的最主要方法。 未发生记忆效应时，AM/AM、AM/PM曲线为一条平滑曲线，代表同样输入功率时不同时刻PA的特性保持相同。

2024年10月24日 · The plot is called the AM-to-AM (AM-AM) response (the amplitude-dependent amplitude response) of the amplifier. The AM-AM characteristic is linear at low input powers, …

How to plot the AM-AM and AM-PM plots? The AM-AM and AM-PM plots are based on a model that assumes the input to the power amplifier is a single unmodulated tone. According to the …

2024年10月14日 · The first file generates AM/AM plots, whereas the second plots AM/PM, the syntax is similar

The AM/AM characteristic of the DUT is obtained by plotting the magnitude of its instantaneous gain (|G (|x in |)|), typically expressed in dB, as a function of the DUT’s instantaneous input …

2011年7月11日 · I have designed a Power Amplifier and have obtained AM-AM and AM-PM plots. I would like to include the S21 parameter file (which has both am-am and am-pm) and run …

This example shows how to characterize a power amplifier (PA) using measured input and output signals of an NXP Airfast PA. Optionally, you can use a hardware test setup including an NI …

Abstract — Non-linear amplifiers distort signal constellations through their amplitude (AM/AM) and phase (AM/PM) curves versus input amplitude. This causes an increase in the average Error...