BIOS version Finding. CPU support List. Technical Support. FAQ. PC DIY Installation. Debug LED Troubleshooting Checklist. Latest BIOS Update. Latest Driver Update. ... Information published on ASRock.com is subject to change without notice. | ...

2023年11月7日 · To clear the CMOS on your ASRock motherboard, you will need to locate the CMOS jumper or dip switch on your motherboard. This is usually located near the battery, and it may be labeled “CMOS” or “Clear CMOS.

Step 1 – Please turn off the power supply and remove the power cord from power supply. Step 2 – Refer the user manual to find the clear CMOS switch or clear CMOS jumper. (Depend on each model) Link: http://www.asrock.com/mb/index.asp [Clear CMOS switch] – The Clear CMOS switch can be found at rear IO.

2021年11月11日 · However, when looking for at the manual for his motherboard (Asrock Z390 Phantom Gaming ITX), I couldn't find anything on the CMOS battery in there, only on how to reset the CMOS.

2015年8月12日 · Below I will outline a foolproof method to achieve a full CMOS clear. 1. Disconnect the system's power from the wall. 2. Press and hold the power button for 10 seconds to be sure residual power is discharged. 3. Place the "Clear CMOS" jumper in the clear position. 4. Remove the CMOS battery. 5.

Step 1: 请将电源电源供应器自主板移除。 Step 2: 参考使用者手册以找到CLRMOS接头，该接头应如下图所示。 Step 3: 使用一导电物体 (如回形针、钥匙……)将CLRMOS接头短路约30秒。 Step 5: 静置五分钟后即可接回电源并开机。

How to clear CMOS on the ASRR motherboard and system? 1. Disconnect the system power cable. 2. Remove the CMOS Battery. 3. Press the power button to drain residual energy. 4. Touch/short the 2 points/pads on the CLRMOS pad with a paperclip for at least 5 seconds. 5. Power on and re-check to the system. © 2025 ASRock Rack Inc.

I. CMOS clearing: https://www.asrockrack.com/support/faq.asp?k=CMOS. II. Reseat all your hardware components and cables, make sure they are installed to the motherboard properly. III. Remove all other hardware components until there is only one CPU and DIMM left, then try booting up again. IV.

2024年5月9日 · press and hold “reset cmos” button for like 30 seconds. switch on power supply. press power button (first boot may take a few minutes). Wait for the light to go off, or press the power button to discharge capacitors instantly. Leave power in and just press the cmos button. I have the Taichi Lite and that’s how I do it.

2020年6月16日 · The 2 pin CLR CMOS jumper is on the bottom right. Just to the left of the pair of fan headers down there.