18042/P1634/005684 - Accelerator Position Sensor 2 (G185): Signal too High Possible Symptoms Malfunction Indicator Light (MIL) ON Reduced Engine Output Possible Causes Wiring and/or connections faulty Sensor (G185) faulty Possible Solutions Have a look at the Pedal Position Sensor assembly, not the Throttle Body.

2009年3月26日 · DTC: 18047 - Accelerator Pedal Pos. Sensor 1/2 (G79/G185): Implausible Signal? Pulled ECU out, box was dry, blew out connectors anyway, pulled apart and blew out the connectors under the ECU, no apparent evidence of any moisture. 1. Replaced pedal assembly with brand new unit.... problem returned. 2.

2020年5月28日 · I have been struggling with this fault code on my 2008 Audi S4. It comes on and off, mostly on. I have searched the forum and have seen some post/threads but no clear solution that have fixed my issue. - wiring harness from O2 sensors plug to ECU. What's the best way to do this? I appreciate any help/info anyone may have.

2014年8月15日 · Hello, Have a Seat Cupra 2011 and I got Fault Code 008487 - Accelerator Position Sensor 2 (G185), please help....I have tryed to do the Throttle Body Alignment using my VagCom but it doesn't work, What can I look for? This is a Print of What I got. Thanks!

2016年4月3日 · Use the Measuring Value Block group [030] to view these two sensors, field 1 (G79) and field 2 (G185). These values must increase or decrease incrementally when the accelerator pedal is depressed.

2007年4月25日 · A4 (B5 Platform) Discussion - 18041 - Accelerator Position Sensor 2 (G185): Signal too Low P1633 - 35-00 - - - Doh!

2024年1月12日 · About a year ago I ended up with a EPC & ESC light, which was throwing the code "implausible correlation" between the TPS sensors (G79/185).

2011年7月18日 · Both the egt sensors and the accelerator pedal sensor. will put the engine into limp in mode. The codes do seem unrelated, until you search the accelerator code and realize how many people have the exact same batch of codes. Several people with these codes have stated they swapped pedal sensors and egts with no success.

2011年12月23日 · So far I have replaced the accelerator pedal and both O2 sensors but the fault code comes back immediately when cleared. All visible wiring & connectors look fine but I haven't traced them all back to their sources yet. VCDS Block 62 shows that Pedal Position Sensor 1 (G79) reaches 76.6% max and Pedal Position Sensor 2 (G185) reaches 45.7% max.

2022年5月4日 · If you keep getting the G185 error, fit the new revised from 2010 pedal 1K2 721 503 AJ it is a five minute job but £148.61, the Hella 6PV 011 040-711 is a third of this. The voltage issue is pretty obvious but your early cable is letting you down here by not showing the voltage.