2020年6月9日 · 05 Audi A8 Having issues with code 17476 -Intake air switch -over valve (n335) P1068-004- Open Circuit.. 1 Where is the location of this valve ? I see 2 valves in the front of the engine but dont know if its any of these 2 . Any help would be appreciated . Tuesday,09,June,2020,10:43:35:64823

2017年8月13日 · Parking brake error, epc error, abs error, codes for MAF, codes for intake manifold etc. Disconnected the n335 and cleared all DTCs from the module and it went back to just a rough idle when cold and some hesitation between gears (which could also be mounts).

Replace failed vacuum lines or faulty vacuum solenoid (N316). Check Intake Manifold Runner Position Sensor 1 (G336) and wiring, see repair manual. Some vehicles may have a vacuum solenoid valve (N335 or V63) located under the air filter housing.

2021年7月7日 · AudiWorld Forums Audi Models Audi S4 / RS4 RS4 (B7 Platform) Discussion Anyone here have the part number for the N335 intake air change over valve?

Some vehicles may have a vacuum solenoid valve (N335 or V63) located under the air filter housing. Failure of this solenoid or the vacuum lines may cause insufficient vacuum and cause P2006, P2007 and P2070 fault codes. TSB 24-08-76, 01-14-76 or TPI 2019485 has some information on testing for vacuum leaks.

The electrical solenoid valve for intake air change-over valve -N335 actuates a mechanical valve through vacuum, which is housed in the air cleaner housing. The electrical valve can be tested via the final control diagnosis.

2017年8月13日 · After some research I've determined I need a ignition service kit from ECS and 034 Density Mounts. However the air intake N335 issue and oil temp sensor issue don't seem to have many answers. Anyone have some insight on what needs replacing/checking? Anyone ever deal with these before?

3 Intake Air Switch-over valve (N335) ‹› Activation for flap in air filter a - T-connector for vacuum supply from intake manifold change-over valve b - Vacuum supply from intake manifold c - Vacuum line to low pressure reservoir (vacuum reservoir) d - T-connector for vacuum supply from Intake Air Switch-over valve (N335) and low pressure ...

2019年2月13日 · Im new to the forum lol I drive an A6 C6 4.2 I have scanned my A6 with a VCDS and need help with locating some of the error codes: • I would like to know the location of the …

Replace Intake Air Switch-over valve -N335-. If specified value is obtained. Check voltage supply. Checking voltage supply of intake air switchover valve. test kit. Switch ignition on. LED must light up. LED does not light up. Check fuse for intake air switch-over valve (relay- and fuse holder in instrument panel, right side). If fuse is OK.