2014年1月30日 · So i booked an appointment with my local BMW and they tried coding the used module with ista/p but that program said dsc module not compatible. So I bought a new one today for $489.00 new Bosch. There are a few people that said that they didn't have to code the module just unhook the battery and install the module.

Customer: 2005 bmw 730li abs light on fault code d98e no message from dsc. 5e9a valve relay . After replacing battery. Already replaced abs module.

2020年10月14日 · Many codes (abt 5-10) saying no message transmitted from DME. also.... Trans code : CF07 communication fault PT-CAN. so no communication to transmission as well as the DME. New battery n registered. Changed IVM Module. happened after a mechatronic seals and fluid change, had to pull the engine for starter bracket repair,

2024年7月12日 · Change your battery as a lot of those error codes suggest power issues. Make sure you code in your battery as well and replace with an appropriate amperage too. Afterwards, then if the issue persists continue with solenoid replacement with …

2020年9月4日 · Checked front and rear resistors both 120 ohms. Pins 6&14 not used by BMW for OBD can bus. Can a failed module cause comm failure on entire bus? For example ABS. All I'm getting from the code reader is communication fault PT Can Bus. Last edited by Harpmaker; 09-12-2020 at 02:55 PM. Reason: incorrect information.

宝马d98e故障码含义. 宝马d98e故障码通常与车辆的电子控制系统相关联，具体涉及到的是发动机管理或燃油系统。这一代码可能提示存在某种特定的系统错误或故障，需要专业诊断工具进行详细分析。 宝马d98e故障码常见原因. 1.

当d98e代码出现时，通常意味着座椅传感器出现了问题，可能是因为传感器本身损坏、脏污，或是与座椅连接的线路出现问题。 应对座椅传感器故障：诊断与修复

2021年4月16日 · 宝马d98e故障你好，当前咨询的人数较多可能回复不及时，如果是车辆故障问题，建议先用电脑检测一下具体故障原因，搜索“汽车大师”可以随时咨询汽车问题，24小时在线解答。

2022年5月12日 · These are BMW Hex codes, so they are harder to get diagnostic info on it. The 5EE4 is telling us that the DSC (dynamic stability control) has an internal pressure sensor issue. The others are just telling us that we have an issue with the DSC except for the 29CC.

2023年10月26日 · Put the key fob in and tried to start the E66 - no start no crank. Pulled out the scan tool to see what codes popped up. Code AOBD = CAS output, wake up line current. I ordered a new IVM, TCM, and CAS and had it flashed, still have the same issue. However my radio is not working but was before this happened.