2003年2月3日 · It is shown that the position of the XRD peak for graded film was between that of BST (50/50) and BST (10/90). This is evidenced by the two distinct peaks from 50/50 at …

In this paper, a non-toxic water-soluble copolymer of isobutene and maleic anhydride (Isobam) was used for gelcasting of Ba0.5Sr0.5TiO3 (abbreviated as BST50) ceramics as both …

X‐Ray diffraction (XRD) patterns and Scanning electron microscopy (SEM) images reveal that such BFM-PT thin films show single perovskite structure and smooth surface without detected …

From the XRD pattern shown in Figure 2c, it can be seen that when the sputtering voltage is 0.75 kV, a crystalline film is identified as a perovskite structure due to the presence of a strong...

Six-layer Ba0.6Sr0.4TiO3 (BST) films are prepared by an improved sol-gel method. The effects of various preheating methods on morphology and dielectric properties are studied. XRD results …

2020年5月22日 · BST is essentially a perovskite-based solid solution of barium titanate (BaTiO 3) and strontium titanate (SrTiO 3), where BaTiO 3 is in ferroelectric (polar) phase at room …

properties of PVDF/BST nanocomposites have been studied using X-ray diffraction. The XRD results showed that the BST nanopowder obtained by hydrothermal method with a perovskite …

通过对BST 铁电薄膜的厚度、XRD 图谱、SEM 图像和电滞回线进行分析，优化了制备BST 铁电薄膜的 工艺条件。 研究表明要想得到单一钙钛矿结构的BST 铁电薄膜，退火温度要高于 800℃ …

In order to properly measure the BST films, grazing incidence XRD (GI-XRD) measurements are taken. With this technique, the incident angle of the X-rays to the substrate is fixed at a low …

在本工作中，制备了包含不同负载量的铜纳米线 （cunw）、ba0.7sr0.3tio3 （bst） 和 bst@cunw 杂化纳米颗粒的杂化环氧纳米复合材料，并分析了其微波吸收特性。本研究中使用的纳米颗粒 …