2023年9月12日 · Bus stalls when I try to drive. So I just drove my Bus about 30 minutes. I parked for about 20 minutes, and now it won’t move. It stalls almost instantly once I let the clutch up. It’ll start and idle, and at first it would die when I gave it throttle in neutral, now it revs up as expected.

2018年5月17日 · 当执行OIR（Online Insertion and Removal 在线插入和移除）板卡时，背板总线(BUS)上会产生Stall信号，以防止背板数据损坏。 BUS stall 会阻止数据包传输到背板，这会导致在暂停期间流量中断。

2024年1月22日 · Does that mean the system bus is stalled or just the Flash memory interface? For example what happens if i have an interrupt, which is running from RAM, while the bus/Flash memory interface has been stalled because a Flash read operation has been executed while a Flash write operation is ongoing?

2023年8月19日 · On the F767, with the firmware running entirely in bank 1, and performing a mass erase on bank 2, I'm getting bus stalls that block operation of the firmware at random times during the mass erasure. This seems counter to the documentation in …

2016年9月28日 · 1977 Bay Widow Fuel Injection Starts and Idles,stalls Given Gas 1979 2.0 L FI stumble '79 CA FI bus ran fine then suddenly won't start 76 bus stalled, ran perfectly and then didn't 1979 Westfalia won’t start after sitting for 2 years 76 bus stalled, ran perfectly and then didn't, JUST WENT through my fuel system

2021年8月25日 · The most important tips for drivers to follow at rail crossings include obeying signs and signals, always looking both ways, knowing the length of your bus and size of the containment area, and evacuating if the bus stalls or stops on tracks.

school bus stalls or is stuck on the tracks or you are required to evacuate your school bus for any reason, review these steps: a. Know before you go. Scout your route. Write down the crossing number of any crossing along your route before the school year starts. Note the safest location at each crossing where you would direct riders in

Bus Stalls or Trapped on Tracks. If your bus stalls or is trapped on the tracks, get everyone out and off the tracks immediately. Move everyone far from the bus at an angle, which is both away from the tracks and toward the train.

2011年2月14日 · When one of our DT's all of a sudden stalls while it is sitting there idling, it is a bad ICP sensor (located under the valve cover). We don't have any of the 7's. Usually ours give an ICP code when this happens.

2019年2月14日 · I am writing & erasing flash during operation, and this seems to cause a bus stall which prohibits all execution from flash during these operations. AN4808 seems to indicate that if you use a dual-bank device you can avoid this by executing out of …