This is the SubReddit for the Creality CR-10/CR-10S 3D Printer. Please be friendly and helpful. Message and mods before posting any sales links/affiliate links. Full rules are in the "Community Rules" link at the top of the sub.

2020年12月1日 · My current printer is a PowerSpec Duplicator I3 Plus (Wanhao I3 Plus clone) with several mods to make it produce good prints. Most of what I've done to it (minus the all-metal hotend) is already stock on the CR-10 V3, or isn't necessary …

2021年12月31日 · I am about to pull the trigger on a new CR-10 V3 and was planning to buy a CR Touch, but am seeing conflicting information about it. (Everything I've read says its better than a BL Touch.) Some sites say the CR Touch requires a 32 …

I got my cr 10 V3 last week . Great small print to begin with , but larger foot print is just about impossible as the bed is warped by up to 0.2 mm, high spot in the middle of the x -axis. I guess I could fix this easily wit a magnet plate but they seem to be unavailable unless you order from China. Waiting for BL touch , on back order.

2020年10月5日 · Turbo is basically just the "normal" sized SKR v1.4, but with a 20% higher cpu clock. The SKR mini is a smaller cost reduced version with just 4 stepper drivers the mini e3 is a version that is specifically designed to fit into an Ender 3 (that's what the e3 means), but the CR-10 and Ender 3 and many other Creality machines have all the same board size.

2022年9月15日 · I recently purchased a CR-10 V3, and while it's great and all, I've begun to get the itch to upgrade it's functionality. Being fairly new to this, I'm wondering what upgrades are out there. (BlTouch, touch display, wifi enabled, useful Marlin (or even non-Marlin) plugins, or other upgrades) Any guiding suggestions/personal experiences would be ...

2022年1月10日 · This is the SubReddit for the Creality CR-10/CR-10S 3D Printer. Please be friendly and helpful. Message and mods before posting any sales links/affiliate links. Full rules are in the "Community Rules" link at the top of the sub.

2022年11月1日 · This is the SubReddit for the Creality CR-10/CR-10S 3D Printer. Please be friendly and helpful. Message and mods before posting any sales links/affiliate links. Full rules are in the "Community Rules" link at the top of the sub.

2021年9月8日 · This is the SubReddit for the Creality CR-10/CR-10S 3D Printer. Please be friendly and helpful. Message and mods before posting any sales links/affiliate links. Full rules are in the "Community Rules" link at the top of the sub.

2021年11月20日 · I've got a few CR-10 v3 printers that I have been using with BLTouch, with the Official Creality BLtouch firmware. I've been getting this message in Octoprint though recently. Warning: Firmware Broken. Your printer's firmware is known to have a broken implementation of the communication protocol. This may cause print failures or other annoyances.