2017年5月22日 · Correct, the California corner means the sheathing is only nailed to a stud on the outside corner of THAT wall, while on the joining wall it would be nailed to a 5.5" stud + 1.5" sideways stud (so a win/lose situation). Now I only question the one side of the wall that truly only nails into that 1.5" of material.

2021年6月29日 · Measure off the corner -- but offset the measuring tape 3/4" beyond the end of the plates. This is half the width of a stud. It makes the first bay a little narrower and pulls all the studs in that wall 3/4" closer to the corner. I do it so that the first sheet of plywood can align flush to the lower end of the wall and centered on the 4th stud.

2013年3月16日 · When I designed and (personally) built my own house in the 1980's this option was fairly new and considered the best framing detail for combined structural integrity an energy efficiency. Google on "California Corner" and you will get hits, including videos, that appear to indicate that it still is considered an excellent detail.

2020年8月4日 · 16" on center framing spacing corner - optimize for butt- vs by- wall, interior vs exterior panels? 0 Shingles Setup for California Addition - Valley between New and Existing

2018年12月29日 · If maximizing insulation in the corner is your number 1 concern, then option 1 (though I'd do it with a strip of 5/8 plywood, rather than clips) is good. Option 2 (frequently called a california corner) is better in terms of giving easy bearing to drywall. Option 3 is poor for insulation and doesn't optimize wood use.

2016年3月10日 · So I just framed two walls that form an interior corner. When I layed out the walls, I did the typical mark the centers on the 16's. What I did not account for, however, was the corner. I did a California corner, which means that the drywall is not actually starting from the end of the baseplate (for one of the walls), but rather 3.5" from the end.

2005年2月28日 · They also call an alternate method of framing a corner a 'California corner' where fewer pieces of lumber are required, and it's reportedly faster. RE: California Framing Exclusivity FalsePrecision (Structural) 28 Feb 05 19:32

2023年11月19日 · We're having a metal railing installed, and I need to add blocking behind the drywall to reinforce this corner and receive the metal railing after drywalling. My thought was to just double up 2x4s and screw them into the existing stud, with a few toe screws and lateral braces to fix it to the bottom plate and adjacent stud.

2013年11月22日 · I am working in a garage and need to run electrical wire through a corner. I cannot go over the corner through the ceiling (a long story), and going through the studs at a right angle will be a significant challenge. Since this is a garage, I'm ok if …

2003年4月10日 · RE: California framing scherry (Structural) 11 Apr 03 18:14 seems to me that California Framing is the old term for platform framing, (as opposed to balloon framing) when discussing light wood framing for houses or small commercial structures...I think. i will check this weekend and see if i can find a reference for sure.