1Ø SCHEMATIC DIAGRAM NOTES: 1. Use Copper Wire (75ºc Min) Only Between Disconnect Switch And Unit. 2. To Be Wired In Accordance With N.E.C. And Local Codes. 3. If Any Of The Original Wire, As Supplied, Must Be Replaced, Use The Same Or Equivalent Type Wire. FIELD POWER WIRING GROUND SEE RATING PLATE FOR VOLTS & HERTZ DISCONNECT …
This publication contains Wiring Diagram information for the 30XA080-500 air-cooled liquid chillers with electronic controls. These chillers are equipped with ComfortLinkTM con-trols and electronic expansion valves. NOTE: For operating sequence, refer to the Controls, Start-Up, Operation, Service, and Troubleshooting literature.
Refer to the appropriate drawing for accessory wiring. The following accessories are shown on the main control box circuit drawing (Fig. 8): thermostat, remote economizer position override, remote economizer minimum position set point, remote 4-20 mA …
Carrier TEMP Thermostat — The Carrier TEMP Sys-tem is a control system which includes a relay pack, TEMP system thermostat, sensors and appropriate wiring. The TEMP thermostat is the system controller and works much like a room thermostat, but …
Fig. 6 – Wiring Diagram — Model size 5 Tons, 460/3 Copyright 2013 Carrier Corp.S 7310 W. Morris St.S Indianapolis, IN 46231 Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
Use Copper Wire (75oc Min) Only Between Disconnect Switch And Unit. To Be Wired In Accordance With Nec And Local Codes. If Any Of The Original Wire, As Supplied, Must Be Replaced, Use The Same Or Equivalent Type Wire. Use 60 Amp class K Fuses Only, For Replacement. 328613-101 REV.
Use Copper Wire (75oC Min) Only Between Disconnect Switch And Unit. To Be Wired In Accordance With N.E.C. And Local Codes. If Any Of The Original Wire, As Supplied, Must Be Replaced, Use The Same Or Equivalent Type Wire. Replace Low Voltage Fuse With No Greater Than 5 Amp Fuse.
This publication contains Wiring Diagram information for the 30RB060-390 air-cooled liquid chillers with electronic controls. These chillers are equipped with ComfortLinkTM con-trols and electronic expansion valves.
Need a product guide or manual? Just enter the model number below, and we’ll give you a list of links to all the documents associated with it. If you need service, or you need to troubleshoot an issue regarding your HVAC system, it always helps to know the model number.
Below we provide Carrier HVAC contact information and direct links to free downloadable installation, service, wiring diagrams, and users manuals, focusing on hard-to-find manuals for older models or discontinued equipment.
Service valve gauge port may not be equipped with Schrader valve (valve core). To prevent personal injury, make sure valve stem is back-seated (counterclockwise) before removing cap. Wear safety glasses and gloves when handling refrigerant. Symbols …
Fig. 1 – Wiring Diagram — Model sizes 18 -- 48, 208/230--1 NOTE : Must use thermostat and sub--base or Infinity t Control as stated in pre--sale literature. 2
View and Download Carrier Base Series wiring diagrams online. With Puron, 1-1/2 to 5 Nominal Tons, Single and Three Phase. Base Series air conditioner pdf manual download.
This publication contains Wiring Diagram information for the 30RB060-390 air-cooled liquid chillers with electronic controls. These chillers are equipped with ComfortLinkTM con-trols and electronic expansion valves.
1 SCHEMATIC DIAGRAM NOTES: 1. Use Copper Wire (75ºc Min) Only Between Disconnect Switch And Unit. 2. To Be Wired In Accordance With N.E.C. And Local Codes. 3. If Any Of The Original Wire, As Supplied, Must Be Replaced, Use The Same Or Equivalent Type Wire. FIELD POWER WIRING GROUND SEE RATING PLATE FOR VOLTS & HERTZ DISCONNECT …
The information contained in this manual is in-tended for use by a qualified service technician fa-miliar with safety procedures and equipped with the proper tools and test instruments. Installation must conform with local building codes and with the National Electrical Code NFPA70 current edition or Canadian Electrical Code Part 1 CSA C.22.1.