2013年8月18日 · Putting in a light wont solve the issue. The problem is somewhere once the car is running there is power getting from the alternator back into the electrical system. If everything is wired properly there is no need for a diode. The diode is compensating for faulty wiring. This is a common issue with aftermarket wiring.

2013年12月24日 · I have a transplanted 1992 chevy 350, TBI in an early bronco. I have an after-market body wiring harness and an after-market engine wiring harness. There are no connectors on the after-market engine harness for the alternator, if I recall correctly. I also have the OEM engine harness for reference.

2008年4月25日 · This diagram will let the alternator charge, HOWEVER, because the alt is capable of output @ idle, your vehicle will prob have RUN-ON problems; because the ignition can get fed by the alt thru the VM connections. TO eliminate …

2007年7月21日 · I have a 1940 Plymouth pickup with a 1973-76 Chevy 350. I had to install a new ignition switch and I have new problems. When I first hooked it up I had the ignition going to a ignition power block for all the ignition needs. I also had the alt wire from the plug going to the ignition part of the switch.

2011年12月28日 · If its a 10si or 12si alternator you also need to wire the two wire plug. - Terminal 1 (or R) is connected to switched power from the ignition. However, there should be a small dash light bulb connected between the wire and the ignition, or you should have a 35-350 ohm resistor in the circuit.

2007年1月26日 · Doc here, imp: Your Instructions are correct.. Power comes from the battery, to the solenoid, where it picks up the main fuse buss support wire (red 10 ga wire) and The alternator output wire (what ever color 10 gauge wire is designated) Fuse links should go Between the buss support and alternator wires and the big bolt on the solenoid (if not already provided).

2004年9月30日 · Good info. I have a situation where at idle the alternator is putting out 13+ volts. When in gear and running drops as low as 8 volts. Scratch your head on that one! Had both alternator and battery checked. The wires from the alternator run to the starter. I have headers and getting to the starter is a real pain. My plan is to rewire #1 and #2.

2008年5月3日 · I have a 1955 2nd series Chevy truck and I put a 350 engine in it. It had a generator and I am going to put an alternator back in it. Right now I just want to add enough wiring to be able to drive it in and out of the shop and maybe keep the battery charged.

2012年9月1日 · I just tossed a stock serp belt setup onto my 1973 Chevy C10 it originally had an SI alternator, a 3 wire set up. One large red wire for battery on the stud on the back, and 2 wires to spade connectors on the alternator. The serp setup …

2010年5月10日 · After looking at the diagram, I hesitate to say it'll work as-is. I much prefer to go by the existing wiring loom and a diagram of same to use for wiring the engine ignition and starting systems. If you have an HEI, the distributor needs to get full battery voltage- …