2011年3月1日 · I have a router Cisco 881G, DSL was running. Yesterday we got 3G, now I need to config to get work 3G and also failover between DSL and 3G. I hope someone will provide me step by step to achive above would be appreciate. Below are some outputs for more inforamiton: #sh cellular 0 secu Card Holder Verification (CHV1) = Enabled SIM Status = Locked

2012年5月23日 · Hi, today I received a Cisco Router 881G with PCEX-3G-HSPA-G for a customer that ordered a Router with the feature to send/receive SMS and to remotely active the 3G Internet connection through SMS. I believe that the router that meets this requirement is the Router 881G that I received today. In pa...

2010年4月7日 · Hi All, My customer proposed to buy Cisco 881G Router. Our Requirements is to terminate both UMTS and DSL connections and is able to switch to UMTS if the DSL line fails. And configure site to site DMVPN. Can any one please suggest me about the UMTS configuration and how it will be switch to UMTS ...

2010年11月9日 · Hi Everybody, I have a problem to configure reverse telnet in cisco 881g router witch have the Console and the Aux port in the same physical port. How to ensure that the aux port in use instead of the console port ? My need is to access to a cisco switch in the same lan as the router. I have con...

2011年1月27日 · Hi everybody, We bought new cisco 881G-K9 router: NAME: " 881G ", DESCR: "881G chassis, Hw Serial#: xxx, Hw Revision: 1.0" PID: CISCO881G-K9 , VID: V01 , SN: xxx ...

2021年12月14日 · Hey guys, I'm looking for a list of outdoor 4G antennas supported on the Cisco 881G-4G router. The router has a TNC connector as far as i can see. It comes standard with 2x 4G-LTE-ANTM-D , but i'm specifically looking for outdoor. I've searched for

2011年3月16日 · Dear All, I have scenario in which we need to connect 2 locations by 3G (data line) SIM card. Hence I am request you all to reply me whether we can use cisco 881G for this purpose? Thaking you all in advqance for your valuable suggestions.

2019年7月25日 · Hi I am unable to configure Cellular LTE profile for SIM slot 0 on Cisco 881g router as it saying the following command is in valued, Router#cell 0 lte profile create 1 net.com I assume the router support only GSM but my SIM card will work only with

The cisco 881G cellular interface configures 3G dialer and I also configure GRE tunnel interface thru this cellular interface. My tunnel interface setup keepalive to 10 seconds. so I think that it should not to meet "no data passing over this session"

2013年1月23日 · I would like to configure the 881G to use both the cellular interface and Fe4 WAN port for internet connectivity. Interface Fe4 is connected to an ADSL router. I have configure each interface with a default route and weighting: ip route 0.0.0.0 0.0.0.0 Dialer0 200 ip route 0.0.0.0 0.0.0.0 FastEthe...