2011年1月3日 · Today was the day to test and practice tune my first engine. With the current D16Y7 106hp engine that's in the car now, I upgraded the intake manifold to a Y8. After purchasing the intake through Kijiji, I discovered that the intake purchased was from an automatic. However, the throttle body sent with it was from a manual.

2013年2月18日 · D16Y7 block and head. 75.5mm SpeedFactory Vitara pistons. P2PO Forged 138.3mm rods. ARP2000 bolts. Delta 272 regrind. Brian Crower built head. I ran the Vitara pistons with Eagle rods, but it was very sluggish down low, so …

2012年10月24日 · Doing a D16Y7/Y8 VTEC Conversion Hellow fellow members. I have been reading and gathering information on the VTEC conversion or whatever you want to call it. I decided that I want to do this on my 97 Civic Hatch. I have been gathering the parts necessary for this set up. This is what I have so far: 96-98 Civic EX engine harness

2010年3月17日 · 1) FJ Turbo super kit for D16Y7 (Vitara pistons, FJ rods, complete gasket set, water pump, OEM timing belt, ACL bearings, and more!) 2) ARP head studs (208-4305) 3) Hondata S300 ECU, conversion hardness

2015年5月2日 · I'm messing around with upgrading my d16y7. I understand I will need to do an ecu swap probably will go with a p28. I'm going to do some bottom and top end work but need to understand a few choices I have, better. What are the differences in swapping manifolds y8 or z6 which one is best and for...

2021年5月4日 · Hey fellas and gals it’s and they’s I was just brainstorming on some ideas to make my civic get some speed, i was thinking about doing a mini me build but all in all I want to cut some corners but I wanted to get a couple opinions. I was thinking about getting a z6 head and locking vtec instead...

2007年10月29日 · Do any company makes D16Y7 camshaft ? I know Gude make one, but it seems to be a little weak. :***: My Y7 head is agressively ported and polished, KMS double springs, KMS titanium retainers, homemade intake manifold matched with the head, etc. Im running YCP Vitara's pistons and Tunertoys connecting rods, with a GT3076R turbo. :twisted:

2008年12月30日 · hey guys i am new to this site and honda tuning in general. i have a 91 crx base model that i bought for cheap. it has a bad 1.5 in it. anyway i found an engine on craiglist and the guy says it is a d16y7 vtec. my research shows that d16y7's came out of 96 thru 2000 civics and it is not vtec...

2011年2月2日 · I'm currently building a D16Y7 engine up with upgraded bottom end and bolt on's. What has been done is swap the Y7 manifold for a Y8 with 2 wire IAC. A chipped OBD1 ecu on Crome is running this setup. It has Injector Dynamics 1000cc high impedence injectors in the stock fuel rail and fuel pump, naturally aspirated. Ultimate goal is boosted D16.

2012年5月5日 · tryed a few different methods, this is the way that works best. cant recommend you throw all bolts in a bucket, some bolts look the same size / thread pitch but, are not as strong and that could cost you in the future if it fails. putting the bolts back where you found them is not the worst idea and works good if your doing something simple / less parts involved. torque anything that has a ...