2016年7月1日 · If we have a yealink IP phone and a yealink DECT phone tied to the same extension (Retail environment, employees not tied to a desk, need to move around with a phone) When we call this particular extension or the ring group to which the extension belongs the DECT system is responding with an unavailable/busy which would be ok except that the IP ...

2008年11月14日 · A customer ask me to change its old PBX with a new 3CX installation, but actually there is a DECT structure based on 10 DECT antennas (for indoor and for outdoor) and this functionality is a must for the customer so I must find some devices that could replace the old antennas with new on SIP...

2024年8月13日 · When I register dect via stun registration audio works as normal. I went to another base which only has 1 handset on and registered another handset to that base (base 2) and it is exactly the same - calls to all extensions are good except between the two handsets thats on that dect. Caller has audio but receiver not .

2022年9月15日 · Hello, I am writing regarding custom template for DECT devices on PBX. There are several custom tamplats created on the PBX, but we are unable to assign any of them to the newly added W70B base. Hence my question, how is it in version 18 adding custom tamplates to DECT devices? I don't see...

2022年2月2日 · Hi All, V18 PBX up to date on Raspberry Pi, Grandstream H801 ATA with BT DECT phone BT4600 attached. The BT4600 connected to the ATA is one of these anti cold call DECT phones that sensing a callers number that is not in its directory asks callers to announce themselves and (only then) rings the BT4600 and plays their recorded message to you.

2024年1月19日 · So I have to following very strange situation: remote office connects via STUN to home hosted PBX. Worked fine for years. Upgraded the dect to a W70 base and W56H handheld, and the T46S to a T46U. Registration works fine, you can call and be called with both phones. Both phones are in the...

Follow our guide to easily provision your Yealink Dect phones and Handsets with the 3CX ® Phone System. ☛ Read the guide!

2024年5月9日 · We are currently using V20 with a setup consisting of three DECT phones on a W70B and a T54W desk phone for our client. Typically, everything operates smoothly. However, we've encountered an issue where if one of the DECT phones is in use and a call comes in on the RG (Ring Group), only the T54W desk phone rings, and it does so at a very low ...

2019年12月19日 · The PBX Express install onto GCP actually makes all IPs allowed for INGRES into the PBX via specific ports including 22,443, 5060, 5090 and 9000-10999 etc. the defaults. I can successfully provision the W60B phone, as it says "Provision Success!"

2021年4月1日 · Need Snom DECT M70 handsets to work in both locations. Both offices are connected within the same (LAN) network. 3CX v20 update 4 PBX. Old M700 DECT setup in place (Chain ID 512). But want to renew the whole DECT Setup for M900. I would like to install the new DECT setup parallel near the old setup, so it would not conflict with each other.