Our tables are a relatively short 5 feet in length, 2 feet deep, and 33.75 inches high, which means you can use them for almost anything and put them almost anywhere. You can use them separately to build parts, such as wing ribs, and bolt or clamp several tables together to …

The design of your aircraft will pretty much dictate what kind of hand and power tools you'll need but there is always one common tool that can be used in any workshop-a decent work bench or work table.

Assembly Bench/Table - How large an assembly bench you will need depends on the aircraft you are building. For example, if you are building one of the VanGrunsven RV designs, all you will need is a solid 4' x 8' table surfaced with a good sheet of 3/4" plywood mounted on a rigid frame.

2012年4月5日 · Basically, the 33” legs of the standard EAA bench are now 20 3/8” for the upper leg and 12 5/8” for the lower leg. Another deviation from the standard EAA workbench consists of the top overhanging the frame by 3” on one side and one end of the workbench to allow for easier clamping of parts to the work surface.

2005年6月30日 · I'm starting the fuselage on my 9A and I'm looking at replacing a couple of benches - now that I know what I want. I plan to use the EAA design (but about 2" taller) and use MDF for the top and make it replaceable so I can drill into it when I want to and not feel like I'm ruining the whole thing.

For instance, we need a bench that is about 16 feet long but only a couple of feet wide to do a Pitts fuselage. Then we need a bench five or six feet wide, but only eight feet long to do the Pitts wings and tail surfaces. Every project needs different sized benches to …

2016年12月19日 · EAA Chapter 1000 Work Bench Construction I used the EAA Chapter 1000 Standardized Work Table Plans to build a set of work tables for my project. I have seen other builder sites use time lapse photography/video to record their build sessions.

2018年5月22日 · When building the EAA workbenches, use a solid, but not nicely-finished, sheet of plywood for the top surface, cut flush to the 2x4 frame. Then, get a sheet of finish-grade plywood, butcher block, melamine, or whatever you like, and attach it to the top of the bench using appropriately sized screws from below.

EAA Chapter 1000 Standardized Work Table Plans Bob Waldmiller Originally published June 1992 Building Instructions. BILL OF MATERIALS (to build 2 tables) (1) 3/4" x 4' x 8' Sanded Exterior Plywood (1) 1/2" x 4' x 8' Plywood (14) 2" x 4" x 8' Premium Studs (4) 1/4" x 3/4" x 8' Pine Flat Screen Moulding

2006年9月11日 · Check your workbench flat in all directions. If it is flat, use it. The standard EAA workbench, the plans are all over the place, search for "EAA bench", is rock solid. Glued and screwed, you will never break it. Mine is. 8 feet long 2 feet wide. You can work around the plans and make it as long or wide as you want.