The object of this test procedure is to detail a standard method to measure the electrical resistance of two current carrying members in mutual contact. This test procedure specifies test voltages that will not disturb insulating films on the contacting surface nor cause asperity melting.

2007年12月27日 · EIA 364-108 阻抗，反射系數，返回損失，並且VSWR在時間和頻率領土電子連接器，電報會議或者相互聯繫系統的測試過程測量

Three-Phase PDU, 3x63 A Input/Output, Emergency Stop LX-PDU-63A-3X63A-NA - LXinstruments GmbH By using the power distribution unit, you simplify the ordering process with only one device required. The device is extremely flexible thanks to its modular configuration.

This standard references TIA/EIA-422-B and TIA/EIA-423-B standards for line driver and receiver requirements and characteristics. The standard supports data rates up to 2.1 Mbps.

This EIA Standard is considered to have International Standardization implication, but the International Electrotechnical Commission activity has not progressed to the point where a valid comparison between the EIA Standard and the IEC document can be made.

The Z-Power connectors are power mezzanine connectors with 50 Amp (10 Tail) and 30 Amp (6 Tail) versions. These connectors are single-piece devices which connect two printed circuit boards. The connectors are press-fit to a lower board and subsequently bolted to a second, upper board. 2.0 PRODUCT DESCRIPTION. 2.1 Z-POWER PART NUMBERS .

2014年8月8日 · 该标准的提出会促使 EIA 的成员在生产和销售产品时遵循该标准﹐ 而它也可以由国内外非 EIA 成员自愿使用﹒ 对于推荐标准和出版物中采用的文章﹑ 材料﹑ 方法﹐ EIA 在选取时未考虑其专利内容,故在此过程中 EIA 对任何专利所有者不承担责任﹐ 对任何采用该 ...

This specification is applicable to the termination characteristics of the 75 Ampere High Current D-Sub family of products which provides separable interface of cable receptacle - cable header application. Typical configurations are 2V2, 3V3, 3W3, …

contains interpolated and extrapolated values. Wire length follow EIA-364-70, If wire lengths used are less than those listed above, the current carrying ability of the system will be reduced due to les

It is the intent that the defined method be used as an evaluation technique for the acceptability of gold contact finishes. The method described herein has been selected on the basis of simplicity of equipment, setup and operation.