2023年11月20日 · firmware_canbus.bin Use CAN bus to communicate with raspberry pi / BTT Pi, baudrate = 1000K. Building the micro-controller with the configuration shown below. Once the configuration is selected, press q to exit, and "Yes" when asked to save the configuration.

For over 40 years Executive Coach Builders has been the premier luxury limousine and bus builder. Located in Springfield Missouri, Executive Coach Builders is committed to manufacturing high quality vehicles backed with an exceptional warranty/ aftersales service.

2024年4月20日 · 8) Plug the EBB into the M8P using a USB C cable. 9) Put the EBB into DFU mode by holding BOOT and then pressing RESET 10) Verify DFU mode by checking USB devices

Communication interface (CAN bus (on PB0/PB1)) ---> (1000000) CAN bus speed. ***Note: Only after https://github.com/Klipper3d/klipper/pull/5488 is merged into the main branch of Klipper, will the official firmware support the CAN bus function of STM32G0B1.

Important notes about this board. The probe port only supplies 5v so may not work with certain inductive probes. Before proceeding it is critical that your CAN network is configured for your printer, failure to setup the network will cause a problem when you try to connect devices :) click here and select your controller for setup instructions!

BIGTREETECH EBB SB2240/2209 CAN V1.0 is a tool board for the 3D printing team of Shenzhen BIQU Innovation Technology Co., Ltd. to adapt VoronStealthBurner. It can communicate via USB or CAN, greatly simplifying wiring。 Product Link: https://biqu.equipment/products/bigtreetech-ebb-sb2209-can-v1-0. BOOT and RESET keys are reserved on the main board.

Set the CAN-BUS speed to 1M (it must be consistent with the speed set in the firmware (1000000) CAN bus speed), save (Ctrl+S) and exit (Ctrl+X) after modification, and enter

2024年7月20日 · 适用EBB型号： ebb36、ebb42，ebb rp2040等 其实也适用fysetc以及mks的主板，仅仅是编译参数不同。 下面是具体的操作步骤和代码。

BIGTREETECH EBB36 or EBB42 CAN is a nozzle adapter board specially designed for a 36 or 42 stepper motor extruder, which is launched by the 3D printing team Shenzhen Big Tree Technology Co., Ltd. It can communicate via USB or CAN, which will greatly simplify the wirings.

ebb 工具头需要压线，压线的端子胶壳原装都有配，只需要注意压线线序如上，对应水晶头中间两根线的线序别搞错了，水晶头只用到最中间那两芯，但别买错了，要买6p的，4p的会小一点不适用。24v和接地直接连到开关电源上。