2014年11月24日 · Configuring the router eigrp command with the autonomous-system-number argument creates an EIGRP configuration called the EIGRP autonomous system configuration, or EIGRP classic mode.

2009年10月5日 · Use the router eigrp number command to configure an EIGRP autonomous-system (AS) configuration. In this configuration, EIGRP VPNs can be configured only under IPv4 address-family configuration mode. A virtual routing and forwarding instance (VRF) and route distinguisher must be defined before the address family session can be created.

The router eigrp command entered in global configuration mode with autonomous-system-number argument creates an EIGRP routing instance. It is the first step in configuring EIGRP on a router as done here on R1:

To enable Enhanced Interior Gateway Routing Protocol (EIGRP) split-horizon, use the split-horizon command in address-family interface configuration mode or service-family interface configuration mode.

2025年3月18日 · This tutorial explains how to configure the EIGRP routing protocol on Cisco routers. Learn EIGRP configuration and commands via a packet tracer example.

2021年12月3日 · Enhanced Interior Gateway Routing Protocol (EIGRP) is a dynamic routing network-layer Protocol which works on protocol number 88. EIGRP supports classless routing, VLSM, route summarization, load balancing, and many other useful features.

With this EIGRP Config, we will learn important Cisco EIGRP Commands on Cisco Packet Tracer. For our EIGRP Config Example, we will use the below topology consist of four routers and four PCs on Packet Tracer. You can DOWNLOAD the Cisco Packet Tracer example with .pkt format at the End of This Lesson.

Cisco introduced the “eigrp upgrade-cli” command, which upgraded classic mode to named mode. After configuring this command, it upgraded the classic mode to the named mode without the network flapping or restarting process.

EIGRP-IPv4 Topology Table for AS(1)/ID(10.0.0.1) Codes: P - Passive, A - Active, U - Update, Q - Query, R - Reply, r - Reply status, s - sia status

2024年4月26日 · Step 4: After configuring all of the devices we need to configure EIGRP protocols to the routers. First, click on router0 then Go to CLI. Then type the commands and IP information given below. CLI command : router eigrp 10 network <network id> Protocols for router0 Router(config)#router eigrp 10 Router(config-router)#network 192.168.0.0