2 天之前 · Pretty sure the 128:F05 is from the dash. It should be followed by another three digit number. 128 means it's a code in the ecm and the f05 is the fault type. If it's egr I believe the third number would be SID 146.

The ECM will not initiate a burner ignition cycle for the left extender burner when this diagnostic code is active. Note: Ensure that the diagnostic code CID 930 FMI F05 for the fuel valve solenoid is on hold and that the red diagnostic code indicator on the conveyor ECM display is ON.

The error codes shown are for any forklift with a Nissan K21 or K25 engine. E-Codes are foe ECM or engine control faults. F-Codes are for VCM or vehicle control faults. P-Codes are for meter panel or display detection faults.

2023年12月14日 · Pretty sure the 128:F05 is from the dash. It should be followed by another three digit number. 128 means it's a code in the ecm and the f05 is the fault type. If it's egr I believe the third number would be SID 146.

The Engine Control Module (ECM) monitors the current flow through the terminals. Conditions that Set Code The ECM sets a code if the current flow is too low or the current flow is too high.

The 128 just means that the 28_A and F05 originated from the engine ECM and not another module such as the ABS controller or transmission controller, etc. Customer but the troubleshooting diagram you sent shows the ecm wiring

By visiting our site, you agree to our privacy policy regarding cookies, tracking statistics, etc.

Shop ECUs & Computer Modules for 2005 Ford F-150 with eBay Guaranteed Fit. Great deals. Massive selection from top brands on eBay.com.

The best way to test the TOS is to use the ECM. Attached is a file to show each mode and a complete list of fault codes. I am assuming the codes with * are the active codes.

The ECM has failed. This is unlikely. System Response: The results of this diagnostic code are: Conveyor diagnostic lamp on the machine operator's station will be ON. The left auger will not operate. Note: Ensure that the diagnostic code CID 103 FMI F05 for the solenoid is on hold and that the diagnostic code present indicator on the ECM ...