2016年1月23日 · I use the GPS Rx pin. Just use a 3 wire cable to get gnd and 5V to the Rx. Looking at ia6B pins pointing at you, iBus is on top. Data is the pin to the right (near the edge). Must be connected to the innermost pin (the one labelled GPS rx). So you are sacrificing the GPS option using iBus.

Annoyed at how many videos there are of this with wishy-washy instructions of "strip all the wires and try them in different combinations" to make your own trainer cable - So I put this together...

2017年3月24日 · This is a developers guide to the FlySky FS-i6. As of this writing, porting has just begun. The FS-i6 is a prime candiate for OpenTX as the hardware is inexpensive and relatively good quality. Porting is made easier by the generous inclusion of test pads (with labels!) on the PCB and a populated SWD port.

The FlySky FS i6 system is intended for use with a wide variety of model types (boats, cars, variable pitch helicopters, etc) and accordingly its user interface allows the controls on the transmitter unit to be configured for each of these. Here we deal only with those aspects that are relevant to its use with a multirotor (such as a quadcopter).

Run a wire from the 3rd pin of SWB, the only one that's free, to the soldering pad called "SWB" in the image (white wire on the right). Take the 4K7 resistor and bend its legs to match the distance of the soldering pads called "C22".

2022年9月27日 · 富斯FS-i6遥控器原本是一款带有6通道的遥控器，可以用于控制无人机、航模飞机、赛车和船只等，如果将其刷成10通道，则可以增加遥控器的可控性和精度，以更好地控制飞行器或其他设备。

This manual will guide you on how to use the Flysky FS-i6 6 channels 2.4GHz AFHDS2A computerized digital proportional RC airplane and helicopter system. The manual covers topics such as binding, power on/off, key functions, main screen, system settings, functions settings, packaging content, and FCC statements.

2017年2月8日 · I stripped my old samsung headphones and I tried to connect the pin 1 of the i6 DIN plug to the fourth ring of the jack and pin 1 to the tip of the jack. Unfortunately I have no input through the microphone and therefore the raidio is not detected.

2019年4月23日 · Has anyone successfully used the PPM pin on the trainer port of the FLySky FS-I6 transmitter as a PPM input that will transmit to the IA6B receiver? In my google searches I have seen some that say it works, and some that say it doesn't. I am planning on building a DIY head tracker with a spare MPU6050 IMU/Accelerometer and an arduino nano.

You'll use three "breadboard jumper wires" or sometimes called "Dupont" wires with female to female ends. Attach them to the pins labeled "SWCLK", "SWDIO", "GND" as shown in this picture: