2015年3月26日 · Looking for an image that shows the locations for the Oxygen Sensors, specifically Bank 1 Sensor 1 on a 2010 Ford Fusion Hybrid? Thursday, March 26th, 2015 AT 8:17 AM 1 Reply

2023年8月29日 · Hi Amnon and welcome to the Ford Fusion Forum. You may get a better response if you start your own new thread, instead of hopping on an already existing and older thread about O2 sensor locations. Good luck.

2012年9月13日 · From what I can tell, the FFH uses a wideband lambda oxygen sensor in the upstream position. This sensor allows the PCM to precisely determine the current mixture over a greater range than the traditional O2 sensors Ford uses. As a result, this particular sensor is more expensive than most O2 sensors. The correct part number is DY-1120.

2010 Ford Fusion sensor locations. RUDYJ ... 6 CYL; 2WD; AUTOMATIC; 116,000 MILES; Bank 1 sensor 1 ...

Buy a $25 multimeter with 10 meg ohm input and simply diagnose the O2 sensor, set the multimeter to 1V DC and measure the voltage being produced by the O2 sensor, the voltage from the O2 sensor ranges from 0 to 1 volt and I am not sure if the voltage should remain constant at 450 millivolts or fluctuate between 450 - 950 millivolts.

2013年1月23日 · I have a 2006 ford fusion 2.3 4 cyl with 180,000 miles, I do all my own work, but am kinda stumped on the location of the oxygen sensor(s) I have herd there are two, an upstream and a downstream. When i got under the car today i looked for the usual in or around the cat but couldnt find it. Thanks, Bill

The rule is bank one is the exhaust bank with number one cylinder so if a four or straight six, bank one sensor one is the front O2 sensor, if a V engine, it will be the front sensor on the exhaust bank with number one cylinder. Here is a guide to help you get the oxygen sensor changed out.

2014年11月11日 · I just finished replacing my upstream O2 sensor, to fix the the engine light, which coded out as P0130 on my $55 Autozone OBDII reader. It was not that easy, the slotted deep sockets did not work at removing the very frozen-in-the-manifold sensor. But once accomplished the light seems to be perma...

2014年7月4日 · Diagram: Ford Explorer and V8 O2 (Oxygen) Sensor Locations Ford Explorer and V8 O2 Sensor Locations diagram. This shows the location of Ford oxygen sensors on Bank 1 and Bank 2. If you want to know where your O2 sensors are, this diagram is your guide. Hope helps.

2011年2月17日 · newbee here, does any one know the cylinder location on a 2006 fusion 3.0 engine, i have a dead cylinder on number 4 but no way of knowing its location, most likely it needs a plug and coil pack.