2023年10月31日 · Correct Solder Spots on Logitech G203 PCB? TL;DR Need to simulate left click of a Logitech G203 with the Raspberry Pi GPIO. I don't have much soldering experience. Two wires soldered: one for the left click signal and one for a ground wire. Are the points that I previously soldered wires to correct? What might have gone wrong?

2020年1月4日 · Speaking of posts in the shell, the PCB definitely does not drop into place the first time, and sanding down these posts is difficult given their size and delicate nature. I personally found that the best way to move/remove large amounts of PLA is to use a soldering iron set to a low temp (I used 180C) with a narrow tip, and carefully "melt and ...

2019年5月24日 · Replacing Logitech G102 / G203 switches? Thinking of replacing the Omron switches to Huano blue shells, having double clicking issues. But I'm worried if the Huano's are too short. Current switches are Omron (China) D2FC-F-7N (10M). Will it work with the Huano's? the d2fc-f-7n are the short switches, should be the same as huano.

因为部分鼠标的PCB板不止一个，可能一个安在上盖上，一个安在下盖上，两者间用排线连接，如果一下用力过大，可能破坏排线。 3. 尽量选择合适的螺丝刀. 这个是拆解任何东西的时候都要注意的事情，大家应该都有过用不适合的螺丝刀把螺丝扭坏情况吧。 帝亿的拆解视频列表 (B站貌似不允许引用站外的链接，只能是文字了)：

2024年9月24日 · Top-Rated Global Leader in Marine & Ship Items like Industrial Automation, Electrical Equipment & Supplies, Safety Item, Hydraulics Item and Antiques. Our goal is to be the irreplaceable leader in the supply of Vintage & Collectible marine and ship products.

2023年2月27日 · clarification: i never said it was a good idea to do so, but i have seen people chop off the back of the g203 pcb specifically. You can it saves around 4-5 grams. You can also remove the plastic cover of the sensor. A place for discussion, news, reviews and DIY projects related to portable audio, headphones, headphone amplifiers and DACs.

1919 "logitech g203 pcb" 3D Models. Every Day new 3D Models from all over the World. Click to find the best Results for logitech g203 pcb Models for your 3D Printer.

2018年12月3日 · I'm doing a WMO with g203 internals mod and i'm completely done other than the switches don't line up because the pcb is too far back even at the farthest forward, And theres this part sticking out of the pcb that if removed would fit completely perfect, If i cut it off will it ruin anything or make it stop working?

An Easier and Powerful Online PCB Design Tool. 2.9 million Engineers Chose EasyEDA