The are jumper pin arrays for sata specific options. IDE drives could be daisy chained so they had more options so they used 8-pin arrays, but its the same basic concept. jumper a pair of pins to enable a setting.

2012年6月27日 · HDD with 4-pin interface. Looking on the internet, I can see that it exists on all HDD devices, but not on SSDs: SSD without 4-pin interface. On old IDE devices, there was a similar interface used to select operational mode (master/slave), but on SATA it doesn't make sense anymore.

2020年11月1日 · You can now right-click then click on Properties so you can know where is that HDD plugged. Right here you can see which SATA port your HDD is using. Another way to do this is right in the File explorer. Just right-click on the drive Properties>(on the properties window) click on Hardware and there it is on Location that's where is your HDD ...

2013年8月30日 · The bus info fields give you the physical port each HDD/SSD is connected to (ports 0 and 2 in this case). Note that the number may differ if your system has multiple SATA controllers (on-board or via extension cards).

2015年7月11日 · Stack Exchange Network. Stack Exchange network consists of 183 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

2010年6月18日 · SATA wasn't common in laptops until much later...perhaps 2005 or 2006, depending on the manufacturer. My Inspiron 8600 purchased in early 2004 has an IDE/PATA hard drive, and the same model with the same drive …

2015年8月29日 · Open device manager, expand disk drive, you can see the model of your hard drive and the type of connection, for sure write down the model and search on google the hard drive model specification, you will find whether the original hard drive is IDE, SATA, SATA 2 or SATA 3 from the specification of the original hard drive.

You only have 4 SATA ports on your M2A-VM. 2 are marked black, 2 are marked red. There are no distinction in utility for all 4 ports, black SATA ports are ports 1 & 2, and red SATA ports are ports 3 & 4. Just go in serial starting from port 1. It does not affect anything at all. Link to your motherboard manual here (PDF link).

2019年1月23日 · For the most 2,5" external hdds (without extra power connection) i need a Micro-USB-B-to-USB-A-plug like this: I have not seen any other kind of devices which uses a Micro-USB-B-plug yet.

There are two ways you can go to fix this: The simple way and the complicated way. The HDD is a SATA HDD, so you can just disconnect the disk itself, find a desktop computer or another enclosure and insert it there. The more complicated way …