2013年2月13日 · I finally got around to making my shaft puller. Everything came out great, still gotta tweak a couple things but all in all it looks great and works great! One of the main things is the vise clamp are a little small, so I have to m...

2021年5月28日 · Simple Diy Shaft puller I made using a car brake spreader tool and a simple wooden clamp. Brake spreader bought on amazon, drilled a 10mm hole through the brake spreader and cut a groove down to meet the hole. The clamp is very basic, just 2 pieces of wood with bolts going through.

2014年6月10日 · Got bored tonight and decided to try to make a shaft puller. I'll eventually make the diy hydraulic puller, but for now this one will do. It's obviously not for someone who pulls shafts often, but 90% of my pulls are steel shafts so I rarely need a shaft puller.

2019年4月18日 · I built this homemade shaft puller this morning out of some stuff I had laying around the shop. It worked so good that I thought I would share how I did it. I started by finding a flat washer with a inside diameter of .380, this allows the shaft to fit …

2011年11月27日 · But the hobbyist or sideline business may be looking for a less expensive tool -- or looking to trade sweat equity for a lower price. This article presents the plans for a good DIY (do-it-yourself) shaft puller. (Before I continue, Golfsmith and GolfWorks recently introduced budget shaft pullers for about $70. I haven't used either one, but ...

2020年6月3日 · I've been trying to figure out a cheapish graphite shaft pulling setup for a while. I came across some videos on Youtube (here and here) by a guy who built one from a couple of vises. He's from the UK, so he says it cost less than &20. I picked up the vises for about $20 a pop at the hardware store.

2012年10月30日 · I thought I'd share what I made for a shaft puller. All you need are 2 vices, a 1/4 piece of aluminum, and a board to mount it on. The green vice is a cheap $15 Harbor Freight vice. The red vice is an old ski-waxing vice, but you could just …

2014年7月18日 · I built the puller using a $10 can crushing mechanism. Used my dremel and ground away a slot that would fit a .355 taper shaft, which ended up working perfect for the woods. screwed it down to a scrap piece of plywood, and mounted a vise i …

2015年3月17日 · So, what I want to do is build a shaft puller/extractor (to be used on graphite as well as steel). What I'd like to know is what you guys use, whether you built your own, any pictures/directions/recommendations you have (threaded extractor vs hydraulic, etc etc etc) and whether it is actually worthwhile going the DIY route.

2022年7月17日 · This is the brake spreader I bought - https://amzn.to/3AUGazpGolfwrx thread - https://forums.golfwrx.com/topic/1814956-simple-diy-shaft-puller/If you wish to...