Step 1: Put the shifter and transmission selector shaft into the Park position. Remove any existing linkage from the transmission selector shaft and the steering column. Step 2: Install the splined trans arm bushing onto the transmission selector shaft with the open end facing out.
Curt's Corner : How to Replace a Manual Linkage in a 4L60E
Curt from Monster Transmission shows how to switch a manual linkage in a 4L60E transmission. This is a simple procedure, no need to take the valve body or th...
Step 1: If your vehicle already has a shifter of any type installed, disconnect all shifter linkage and remove the shifter and its related hardware (neutral safety switch, back-up light switch, etc.). It is not necessary to remove the Manual Lever Position Sensor (MLPS) on a 4L60E transmission.
Step 1: Remove all of the existing shifter linkage from both the steering column and the transmission. Step 2: Install the trans lever onto the transmission using the factory nut. The trans lever should point down and towards the front of the vehicle at approximately the 7:00 position.
How To Replace A Manual Linkage In A 4L60E - Monster Transmission
Curt from Monster Transmission shows how to switch a manual linkage in a 4L60E transmission. This is a simple procedure, no need to take the valve body or the filter off. You only need to remove the pan and the neutral safety switch if you have one on the transmission.
Adjust the shifter cable: *NOTE: Units that have a rod type linkage are adjusted on the steering column at the firewall. • Remove the locking clip from the cable. • Now you can slide the cable back and forth in the bracket and line it up with the manual shaft pin. • Install the locking clip and connect the cable end to the manual shaft.
if the transmission configuration has changed since the order was placed, you'll need to connect the Quick 4 to a Windows PC and install the Shiftware Tuning Software, which can be obtained from our website (under Support - Shiftware) or the included CD. Using the software, load the calibration that matches your transmission's configuration.
Step 4: Transmission Connectors (4L80E) Connect the Solenoid and TSS cables to the transmission. THE CONNECTORS MUST BE KEYED CORRECTLY for proper transmission operation (see the diagram below for details). Connect both TSS cables according to their labels. Additionally, connect the Neutral Safety Switch and the Backup Lamp Switch.
Discard the stock lever and the stock shifter linkage. Install the B&M selector lever in position using the stock selector lever nut (See Figure #1).Torque the nut to 23 lb-ft. The lever should move smoothly from front to rear with a positive stop in each gear position. STEP 2.
4L60E column shift linkage - The 1947 - Present Chevrolet
2020年10月19日 · Getting set to connect my column shift to the 4L60E transmission. I see that several people are using the Lokar kit with the adjustable bracket that attaches to the transmission. I am planning on machining my own to go there. About how far (radius) is the centerline of the rod connection from the actuator stub shaft coming out of the transmission?