How To Take Apart Center Console Lock - Jeep Wrangler TJ Forum
2016年11月16日 · Remove the lock assembly from your center console lid by pressing on the tabs on the side of the lock, and pulling it out. Remove the center lock out of the entire assembly: press on the circled tab with a slotted screwdriver or anything flat, and then pull the center lock out of the assembly (hold onto the bottom slide while you do this ...
Center Console Lid Lock Cylinder Removal | Jeep Wrangler …
2020年11月23日 · 1) Remove the lid. 2) Remove the plastic trim plate under the lid. This pops out with little force. 3) Remove the six T20 torx screws holding the latch assembly in place. 4) Insert key into lock cylinder and turn it to the "locked" position.
Removing center console lock cylinder from latch cylinder
2009年6月23日 · Remove latch cylinger from console lid; Look at the side of the latch cylinder body under the trim ring, you'll see a slot running 2/3 of the latch body and in the slot you'll see a small catch / tab. Press the tab in with a flat bladed screw driver and …
How to replace the center console lock on a 1997-2004 TJ
2018年3月28日 · Took the barrel out and dismantled the plastic mechanism, found that the plastic rotating barrel was all scratched which was causing it to catch and not rotate properly. So, sanded it down with 1200 and put a bit of silicone lube in it, reassembled in the correct orientation and lo' and behold it functioned perfectly.
Console Lid Lock cylinder removal | Jeep Wrangler Forum
2018年9月30日 · Remove lid as a unit from console. Remove inner plastic from lid. Insert key into lock. Push in tab(s) on side of lock cylinder. Turn key (unlocking direction if I recall correctly) and lock cylinder should "unscrew" from its hole. Good luck.
Center Console Lock Cylinder Replacement | Jeep Wrangler …
2020年11月7日 · I have to replace my center console lid (the arm rest). Looks simple enough but I'll also need to remove the lock cylinder from the old lid and put in on...
Quick fix for your center console lock | Jeep Wrangler Forum
2010年11月29日 · This fix should work for most models and years because the lock is pretty standard. Mine is on a 2003 TJ. The "catching" symptom is caused by the center pin being tooo flat (such as an unsharpened pencil). This fix will round off the center pin allowing it to glide smoothly against the lock plunger. Here we go:
Replacing lock on center console - Jeep Wrangler TJ Forum
2018年2月19日 · Installing my sound Ordnance B-8PTD with 3D printed replacement center console tray
Center console lock question - Jeep Wrangler Forum
2011年3月31日 · When you open the lid to your center console, you will see a torx screw in the bottom of the locking mechanism. Unscrew this torx screw, using cuation NOT to lose it, (slippery little sucker) then the lock shroud will come off. You can then lift the lock unit from the top side of the center console cover. unk:
stock center console lock mechanism | Jeep Enthusiast Forums
2008年4月4日 · On my stock center console, I took out the broken lock mechanism by unscrewing that small screw and bringing out the whole mechanism. Now I'm just trying to take out the part where the key goes and can't seem to get it out. The only way I can figure is to use the key and turn it the other way and it would come out, but that isn't working.
- 某些结果已被删除