2018年4月6日 · Try removing LIN bus wire from generator and see if J533 starts to communicate with J367. Communication status should be seen in CAN gateway MVB 006. J533 - J367 - Generator all share the same LIN bus and one broken device can pull down the whole bus.

2014年10月14日 · Seems the CAN gateway isn't hearing from the battery circuit (J367) or the voltage reg. Apparently if the car doesn't have a separate CAN module (#61) then the CAN Gateway itself reads the battery data directly from the J367 box. I suspect this is the box near the battery that you are seeing.

2019年5月9日 · Re: VCDS Faults - Supply Voltage B+ & Control Module for Battery Monitoring (J367) Clear codes and drive. I think these codes come when the battery either dies or in your case is swapped out. I wouldn't worry about them.

2018年3月8日 · Annoying as the Start Stop is, mines not working either and for some reason that annoys me more. I've also got the 00458 J367 error along with (via Carista) 03705 Voltage Stabilizer. The Battery level on the MMI is always 100% but I can't remember if I activated it via the Green Menu when I was tinkering.

2018年4月13日 · I need guidance for troubleshooting a CAN BUS wire short on my 2010 Audi Q7 TDI. It has a lot of options, so there are quite a few electronics. Can someone please advise me of the recommended troubleshooting procedure, resources (i.e. diagrams and list of cable runs to be checked) as well as any way to isolate the specific area where it's broken?

2024年12月17日 · Battery Monitoring Module (J367): No signal/communication error. Replaced the battery and cleared all fault codes with VCDS. Checked for water ingress and dried out the boot area as much as possible. I suspect the Battery Monitoring Module (J367) might be faulty due to water damage, as it’s near the battery.

2018年7月12日 · Battery testing and charging for vehicles equipped with a Battery Data Manager (BDM - J367). Technical Background When the Incharge 940 is used as a battery charger in auto mode, it performs a battery condition test and may prematurely fail the battery

2023年3月29日 · I have recently replaced the battery on my audir8 v10 and the voltage regulator fault is showing up. There is a setting in one of the ECUs that should be updated when a new battery is installed. My understanding is that it triggers relearning of the voltage levels to prevent false error codes.

A large majority of modern VW/Audi/Seat/Skoda vehicles require the configuration of replacement batteries. The diagnostic steps vary depending on the actual vehicle configuration. Prerequisites: New VW/Audi Battery Installed Aftermarket batteries may NOT have a valid Part Number, Vendor code or Serial number.

2018年7月11日 · 1. If the vehicle is equipped with Battery Energy Manager (J644) or Battery Diagnostic Manager (J367), please perform TSB 2025360, 27 Low Battery Charge: Diagnosis Tips and TAC Instructions before continuing with this bulletin. 2. Verify the battery is good, using one of the below TSBs, depending on vehicle equipment: