Removing and installing parking aid control unit -J446 - (Avant) Removing – Remove luggage compartment side trim (right-side). Vehicles with mounting for jack: – Take jack out of …

2023年11月17日 · I have cleared all fault codes and replaced wheel speed sensor successfully with VCDS and Hex-V2 but this fault is still reported on 2017 Audi TT TFSI 45 Sline. Please …

Update the software of the control unit for the parking assistance control module, J446 (address word 10) using the SVM code as listed in the table below if necessary. Model

2019年1月7日 · I'm attaching a full scan of the vehicle, relevant error shows as: CAN network gateway: 01327 - Control Module for Parking Aid (J446) So, I now need to sort this out...

2011年6月19日 · Hi All My Rear Parking Sensors don't work. VCDS has come up with the following codes: 01327 - Control Module for Parking Aid (J446) 004 - No...

2022年10月21日 · 01327 - Parking aid control unit (J446) 004 - No signal / communication Capture: Fault Status: 01100100 Fault priority: 2 Fault frequency: 1 it may be the computer …

2014年10月11日 · VAG-COM Discussion - Parking Assist not working-fault codes--PLEASE HELP - Hi, I own a 2010 Audi Q5 Prestige S-Line. a couple of months ago my rear parking …

Removing and installing parking aid control unit -J446; Removing and installing rear parking aid warning buzzer -H15 >

On vehicles with parallel parking assist the Parallel Parking Assistance Control Module -J791- is integrated in the Parking Aid Control Module -J446-. - If replacing the control module, select …

2008年6月5日 · According to Audi workshop manual, control unit should be placed on the right side of a trunk, opposite to navigation unit, which is on the left. You say, you had installed …