Tire Pressure Monitoring (J502) incorrectly coded; Low battery voltage can cause this fault code; Possible Solutions. Check Tire Pressure Monitoring (J502) Coding; Check the battery and test …

2022年8月22日 · 01325 Control Module for Ture Pressure Monitoring (J502) NO Signal/Communication -Intermittent is stuck in both ABS Brakes module and CAN Gateway Module What I have done so far: 1. checked fuse F4?

2022年8月25日 · Audi A3 / S3 / RS 3 - TPMS control module J502 No Communication please help - I just got a 2012 Audi A3 2.0 TDI with the DSG trans. Car was wrecked in the front driver side...got her all fixed up and she runs and drives and trying to clear and repair all codes. I replaced airbags and the whole driver side door....I...

J502 - Code control unit. The specified pressures are given on the back of the tank cap or in the Wheels and Tyres guide. Two different pressures are indicated in the part-loaded and fully loaded states. The lowest values must always be entered. Control unit …

2020年5月7日 · After doing so a test drive with properly inflated tires should allow you to clear 01325 - Control Module for Tire Pressure Monitoring (J502) - No Signal/Communication. Reactions: Uwe May 19, 2020 #19

2018年8月21日 · 01325 - Control Module for Tire Pressure Monitoring (J502) Thread starter Mihnea Florin; Start date Mar 18, 2022; Status Not open for further replies. Mar 18, 2022 #1 . M. Mihnea Florin Verified VCDS User. Verified. Joined Aug 21, 2018 Messages 17 Reaction score 2 Location UK VCDS Serial number

Unscrew nuts -2- and take off tyre pressure monitor control unit -J502--3-. Installation is carried out in the reverse sequence. Note the following points: Fit nuts -2- and tighten to 1.5 Nm.

2023年7月27日 · 1) Can any one with working module [65] / J502 module without any errors share their coding and possible adaptation values scan? This would be very helpful as I shall try to bring my module back to factory settings.

2015年1月16日 · I'm a relatively new 2006 S8 owner although I've owned various Audis for the last 15 years or so. My new (to me) car has a few gremlins - one of which is the TPMS. It wont switch on via the MMI, and vcds cant communicate with the module. I've lifted the rear bench to make sure it is plugged in which it is.

2021年4月3日 · It's for VW -- I couldn't find a similar procedures page for Audi, but assuming it's the same? The sensors are dated Nov 2021 so thinking the batteries are still OK.