The P350 pump has a maximum of 130 feet of head pressure and will bolt directly to a variety of motors and brands running around 9 hp to around 13 hp, just be sure to match the proper shaft to pump. This pump also leaves enough room to adapt a 2 inch pulley between the engine and back plate to drive a air compressor or other accessories.

p280 p350 p350s item description quantity part no. part no. part no. 1 hose adapter 1 ha25 n/a n/a 2 outer housing 1 201 301 301s 3 impellar 1 202 352 352s 4 pump seal (ceramic seal) 1 wps3(pt.1) wps3(pt.1) wps3(pt.1) 5 pump seal (spring & …

Double check to see that the Pump back plate contains the ”O” Ring Washer #9 and is in its proper position. Care must be taken not to overtighten as the bolts in the housing as the threads are aluminum and could become easily stripped.

Set the back plate assembly (#5) and mount using the four back plate bolts (#6). Set bolts into place and tighten finger tight then tighten gently with a 3/8 inch wrench. Make sure the seal assembly (#4b_ is in place on outer side of the engine adapter before mounting. Insert Impeller Key (#4c) into center of impeller as shown in figure #4c.

Pump GPM (gal per min) Head Pressure Inlet Discharge P90 100 160 ft 1-1/2" 1-1/4" threaded HP160 200 160 ft 2" 1-1/2" thrd P180 300 160 ft 2-1/2" 2" thrd P350 500 130 ft 4" 3" thrd Skip to content Skip to side menu

Keene P350 pump and 9 hp Honda engine.

Keene's P350 pump gets its drive from a 9 horsepower gx270 Honda engine. This model is designed for Keene's dredge series models: 5000, 6000 and 8200 series of dredges. Pumps a maximum of 450 gallons per minute. Capable of 120 feet of head lift. Pump size is 4" x 3"

2025年2月4日 · <p>Used pump, In useable condition but missing a few things. </p><p>Needs a new mechanical seal</p><p>Needs cap same as used for a garden hose.</p><p>Needs paper gasket. This one had rtv, could do the same. </p><p>5 inch impeller, was …

2019年1月7日 · Keene P280 P350 P350S parts list with assembly instructions (2001), 222 KB pdf file, 3 pages Gold Panning, Sluicing, Dredging, Drywashing Forum

It is used primarily for gold dredges but has uses in many other applications such as aquaculture and removing weeds from lakes and ponds. This water pump should be mounted on a 13 HP engine with a 1″ keyed (3/8″) or threaded shaft. Impellers for smaller 9 HP engines available on request. P350 KEY WAY SHAFT PUMP ASSEMBLY.