I am able to see the leaf nodes forming BGP L2VPN EVPN peer session with the SPINE nodes. However the leaf nodes are not showing even the local MAC address routes on the BGP L2VPN EVPN table. The configuration of one leaf switch is attached.

1. removing all the l2vpn legs from the router SC,PSTN,SB 2. create all vlans on your 3560 SW1 (even the ones on the switch modules for SB and SC) 3. connect trunk port between SB and SW1 via the switch module (this should have been there already as I am only seeing one UCS server so you would need to access your SB publishers anyway over that ...

Use BGP L2VPN EVPN address family to exchange control plane information. Configure EVPN Type 2 MAC/IP advertisement routes. Policy Enforcement with Cisco ISE: Define service templates, class maps, and policy maps. Configure AAA and CTS for policy administration. Ensure policies are downloaded and enforced on leaf nodes . Validation and ...

Remember L2VPN is not completed deployed in an virtual environment. If some functions is implemented in an ASIC, that functionality is not replicated in the current virtual environment. Control plane might be there, but data plane not necessary the there.

The overlay control-plane is an address-family in BGP referred to as "L2VPN EVPN"; the L2VPN address-family will be configured under the same BGP instance that was configured for the BGP underlay. Let’s assume first that the EVPN address-family is added to the same physical-interface to physical-interface peering implemented for the underlay ...

In the diagram, CUST-C is at the bottom on either side and I am trying to configure a L2VPN between the two endpoints. The ISP core is configured with IS-IS as the IGP and MPLS and that is all working fine. I have drawn lines indicating what the actual cabling would look like if i wasn't using switches and sub interfaces.

advertise l2vpn evpn. evpn. vni 10020 l2. rd auto. route-target import auto. route-target export auto . Both VMs can ping their anycast-gateway, but a ping from one VM to the other VM fails. sh bgp l2vpn evpn (below) shows that routes for the L3VNI have been exchanged. pod4-leaf-1(config)# sh bgp l2vpn evpn

Site A ----| SW1-(PE1)----L2vpn----(2PE2) SW2|----- Site B . With normal l2vpn pseudowire what it does it matches the payload forward to xconnect then impose a label in it toward to xconnect peer. Now does by default pseudowire allow l2protocol like cdp stp vtp lldp which inside the payload sent by site A/B traverse to xconnect circuit?

RP/0/0/CPU0:xrv-0#show run formal l2vpn. Sun May 17 15:35:36.073 UTC. l2vpn . l2vpn pw-class SALES . l2vpn pw-class SALES encapsulation mpls . l2vpn pw-class SALES encapsulation mpls protocol ldp. l2vpn xconnect group SALES . l2vpn xconnect group SALES p2p SALES-CC . l2vpn xconnect group SALES p2p SALES-CC interface GigabitEthernet0/0/0/5

Sorry to interrupt Close this window. This page has an error. You might just need to refresh it. First, would you give us some details?