A threaded brass insert and indexed hold down for positive and trouble free sensor retainment. Vacuum ports, and MAP plug that exit on the same side for a cleaner plumbing and wiring install. Isolated booster port for a cleaner ECM reference signal during braking.

Put away your JB Weld, Screws, Toothpicks, Zip Ties, and any of the other garage sorcery that's been used to patch one of these LS1/LS6 MAP sensor housings back together... We all know that it's only fixed "for now".....

2018年12月22日 · Should I be able to replace it entirely with my LS1 MAP Sensor and sensor housing? Are they identical in fit?

How do you know if your MAP sensor is bad? Is there a way to check it? I just replaced my vacuum line that goes behind the manifold and when I put the car back together I got the code p0108 for the MAP sensor.

2012年8月10日 · That MAP sensor housing at the rear of my intake doesn't seem as tight as it should be to hold vacuum. The service manual says only that it is a pressed in piece, and that theres an o-ring seal for it. That would be about a 2" o-ring if …

2024年4月29日 · I am reinstalling my LS1 intake and looking for tip or trick to get the tiny vacuum hose re-connected to the MAP sensor housing on the back of the intake when putting everything back together. I can't get my hand back there when the intake is on but the vacuum line is not long enough to connect if the intake is not on.

i want to relocate the map sensor and brake vacuum outlet on a ls1 inlet manifold, can it be done? The map sensor hits the lip on the firewall.

Replacement MAP sensor connector for the LS1 engine. OEM fit and finish. Only $8.95.

2015年2月13日 · The sensor housing used with the LS1 Camaro, Firebird, Corvette, and GTO attaches slightly differently than the LS-series truck sensor. The Ram Jet 502 accepts the TPI and LT1-type MAP sensor with a mounting boss on the side of the intake manifold.

So, I broke my MAP Sensor putting my FAST102 on my Trans Am. The way they positioned it on the back of the manifold pinned it against the firewall and it snapped. I have a bunch of stuff laying around my garage, and I found what I think is a Fuel Tank Pressure Sensor.