2020年11月8日 · New diesel owner, got a deal on a 06 f350 that previous owner gave up on while trying to fix an electrical gremlin. I bought the truck in limp mode. Only codes are p0707 p0706, tow haul light flashing. no reverse lights working. got it home and started looking into getting codes cleared. Tried...

2012年7月11日 · driving along one day and my truck down shifted hard all the sudden. so i pulled over and checked the codes because of the towhaul light was flashing. i got p0706 and p0707. so that indicates the tss sensor is bad right? i have also hurd that bad wiring on the clutch fan can cause this. so i...

2017年11月14日 · Service stabletrac and check engine lights. OnStar diagnostics said P0706, P0708 and P0700 detected. Truck driven 40 miles to dealer at 45-50MPH, ran fine, transmission is not shifting. The dealer has had for 1 and 1/2 days. They say they "cannot isolate specific failure. Tech is to drive and heat engine up and try isolate …

2014年10月12日 · Truck (2011 D-max) went into fail safe and locked the trans into 4th. The problem seems to be intermittent. After clearing the codes and the truck cooled down, I drove about 10 miles before it did it again. Fluids are good and filter is fresh. I looked up the code and I'm getting P0706 & P0708...

2011年3月31日 · Check engine light came on last night. Scaned it and got P0607 (contol module performance). Can someone help with this code. Is the truck alright to drive?

2009年11月1日 · My 2006 2500 Dmax Allison trans has been acting up . It has thrown the flowing codes: P0756 Shift solenoid B check performance or stuck off P0848 Trans Fluid Press Sensor / Switch B Circuit High P0877 Trans fluid pressure Sensor / Switch D Circuit Low P0700Trans Control Sys Malfunction Any insight > I have 43,000 miles on it.

2010年7月24日 · This may be accompanied by transmission range sensor codes P1705 (TR not indicating neutral on self test), P0706 (TR-P sensor frequency fault) and P0707 (TR-P sensor circuit duty cycle low input).

2009年1月30日 · I've got an 04 duramax lly with the edge w/ attitude installed. Last night coming up the highway running about 70 I had a dodge trying to mess with me so I mashed it going up a slight incline. After a couple seconds truck cut out like it defueled (edge is set up not to defuel) and I had no power...

2009年10月6日 · Help! I just installed a transgo jr and now my trans will only drive in limp mode.The MIL is on and code P0877 comes up on my scan tool. P0877 is for pressure switch 4 (PS4) low signal. I pulled the pan and checked all 9 of the connectors. All of them were correctly installed. Next I pulled the...

2015年12月19日 · •DTC P0706 is not set. •Ignition voltage is between 9-18 V. •Engine speed is greater than 100 RPM and less than 350 RPM. •Engine cranking. Conditions for Setting the DTC The TCM detects engine cranking when the IMS does note indicate park or neutral for 0.2 seconds. Action Taken When the DTC Sets •DTC P0706 is a Type B DTC.