2023年5月24日 · MY 09 Corvette is doing the same thing P0716 input shaft sensor failure. I have only seen it twice so far and it occurred sitting at a traffic light when the outside ambient temperature was hot 91 degrees. The transmission temperature was in the normal range 195-210, the car surged forward and the code set.

2017年9月24日 · P0716 The change in transmission input shaft speed is 1,000 RPM or more for 4 seconds. P0717 The transmission input shaft speed is less than 50 RPM for 5 seconds. Action Taken When the DTC Sets. DTC P0716 and P0717 are Type B DTCs. The TCM commands maximum line pressure. The TCM freezes transmission adapts.

2016年8月1日 · P0700 and P0716; Results 1 to 2 of 2 Thread: P0700 and P0716. Thread Tools. Show Printable Version; 08-01 ...

2010年4月5日 · p0716 Folks, we have a G8 GT with a 418 in it, that recently has started throwing this code pretty regularly. It used to do it once in awhile, but now seems to do it daily.

2020年10月2日 · Thread: P0700 and P0716 trans codes. Thread Tools. Show Printable Version; 10-02-2020 #1. pjs. View Profile

2023年8月31日 · I have a set of computers from a 2008 truck that came with a 15 pin 4L60e. We are using an older 13 pin trans and need to remove the ISS from the tune. I disabled all the ISS switches under Trans> General> Config. Then under Trans Diag, I disables Input Speed Sensor P0717 and turned off P0716 and 0717 in the DTCs. I remember reading that

2009年4月17日 · P0716 - How bad of a transmission fix? Apr 10, 2009 20:21:40 GMT -6 . Quote. Select Post ...

2017年4月5日 · The way I made it work using stock 08 silverado 2wd base 12617631 and tcm 24239927 (flashed with MDI) was to leave ALL diagnostic switches and all TCM P codes stock (p0716 and 17) and under the trans general tab set iss fitted to disable and iss after od to disable.

2011年8月6日 · 2013 OBM A6 CTS-V Coupe Mods: Headers back Billy Boat Exhaust, GripTec 2.65, 8.6 PowerBond Lower, LSX Innovations Solid Isolator, ID850's, NGK TR7IX's, Accel 9070CK Wires, Spectre CAI, SRI Ported Throttle Body, SRI Catch Can, NGK AFRM, 160* T-Stat, 0fx2gv Brick, Hard Line Delete W/3/4" Lines, FB 101 FMIC, Pierberg CWA50, Stoptech Drilled/Slotted Rotors, EBC Redstuff, Cut Stock Springs, Flat ...

2018年3月31日 · This issue has been resolved. Set all torque management for the Trans to 0 except the Downshift table, those were never a problem.